MAX16809_09 Datasheet, PDF (6/20 Pages) Maxim Integrated Products – Integrated 16-Channel LED Driver with Switch-Mode Boost and SEPIC Controller

Integrated 16-Channel LED Driver with
Switch-Mode Boost and SEPIC Controller
3.3V TIMING CHARACTERISTICS
(V+ = +3V to < +4.5V, AGND = PGND = 0V; all voltages are measured with respect to PGND, unless otherwise noted. TA = TJ =
-40°C to +125°C, unless otherwise noted. Typical values are at TA = +25°C.) (Notes 1, 5)
PARAMETERS
SYMBOL
INTERFACE TIMING CHARACTERISTICS
CONDITIONS
MIN TYP MAX UNITS
CLK Clock Period
CLK Pulse-Width High
CLK Pulse-Width Low
DIN Setup Time
DIN Hold Time
DOUT Propagation Delay
DOUT Rise Time
DOUT Fall Time
LE Pulse-Width High
LE Setup Time
LE Rising to OUT_ _ Rising Delay
LE Rising to OUT_ _ Falling Delay
CLK Rising to OUT_ _ Rising Delay
CLK Rising to OUT_ _ Falling Delay
OE Rising to OUT_ _ Rising Delay
OE Falling to OUT_ _ Falling Delay
OUT_ _ Turn-On Fall Time
OUT_ _ Turn-Off Rise Time
t_CP
t_CH
t_CL
t_DS
t_DH
t_DO
t_DR
t_DF
t_LW
t_LS
t_LRR
t_LRF
t_CRR
t_CRF
t_OER
t_OEF
t_F
t_R
C_DOUT = 10pF, 20% to 80%
C_DOUT = 10pF, 80% to 20%
(Note 6)
(Note 6)
(Note 6)
(Note 6)
(Note 6)
(Note 6)
80% to 20% (Note 6)
20% to 80% (Note 6)
52
ns
24
ns
24
ns
4
ns
8
ns
12
70
ns
12
ns
12
ns
20
ns
15
ns
140
ns
400
ns
140
ns
400
ns
140
ns
400
ns
275
ns
150
ns
Note 1: This device is 100% production tested at T_J = +25°C and +125°C. Limits to -40°C are guaranteed by design.
Note 2: Guaranteed by design, not production tested.
Note 3: Parameter is measured at trip point of latch with V_FB = 0V.
Note 4: Gain is defined as A = ΔV_COMP/ΔV_CS, 0.05V ≤ V_CS ≤ 0.25V.
Note 5: See Figures 3 and 4.
Note 6: A 65Ω pullup resistor is connected from OUT_ _ to 5.5V. Rising refers to V_{OUT_ _} when current through OUT_ _ is turned off
and falling refers to V_{OUT_ _} when current through OUT_ _ is turned on.
6 _______________________________________________________________________________________