DG201A_06 Datasheet, PDF (5/12 Pages) Maxim Integrated Products – Quad SPST CMOS Analog Switches

Quad SPST CMOS Analog Switches
ELECTRICAL CHARACTERISTICS (DG201A)
(V+ = +15V, V- = -15V, GND = 0, T_A = full opearting temperature range, unless otherwise noted.) (For more information on TYP
values see Note 3.)
PARAMETER
SYMBOL
CONDITIONS
SWITCH
Analog Signal Range
Drain-Source ON Resistance
(Note 5)
V_ANALOG
R_{DS (ON)} V_D = ±10V, V_IN = 0.8V, I_S = 1mA
DG201AA
DG201AC, D, E
UNITS
MIN TYP MAX MIN TYP MAX
-15
15 -15
15 V
250
250 Ω
Source OFF Leakage Current
Drain OFF Leakage Current
Drain ON Leakage
Current (Note 6)
INPUT
Input Current with Input
Voltage High
Input Current with Input
Voltage Low
I_{S (OFF)}
I_{D (OFF)}
I_{D (ON)}
I_INH
I_INL
V_IN = 2.4V
V_IN = 2.4V
V_IN = 0.8V
V_IN = 2.4V
V_IN = 15V
V_IN = 0
V_S = 14V, V_D = -14V
V_S = -14V, V_D = 14V
V_S = 14V, V_D = -14V
V_S = -14V, V_D = 14V
V_S = -14V
V_D = 14V
-100
-100
-200
-1.0
-1.0
100
-100
100
-100
200
-200
-1.0
1.0
-1.0
100
100
nA
200
1.0
µA
Note 5: Electrical characteristics, such as ON-Resistance, will change when power supplies other than ±15V, are used.
Note 6: I_{D (ON)} is leakage from driver into “ON” switch.
PIN
DIP/SO/TSSOP
QFN
1, 16, 9, 8
15, 14, 7, 6
2, 15, 10, 7
16, 13, 8, 5
3, 14, 11, 6
1, 12, 9, 4
4
2
5
3
12
10
13
11
Pin Description
NAME
IN1–IN4
D1–D4
S1–S4
V-
GND
N.C.
V+
FUNCTION
Input
Analog Switch Drain Terminal
Analog Switch Source Terminal
Negative-Supply Voltage Input
Ground
No Connection
Positive-Supply Voltage Input—Connected to Substrate
Switching Time Test Circuit
Switch output waveform shown for V_S = constant with
logic input waveform as shown. Note that V_S may be
+ve or -ve as per switching times test circuit. V_O is the
steady state output with switch on. Feedthrough via
gate capacitance may result in spikes at leading and
trailing edge of output waveform.
_______________________________________________________________________________________ 5