MAX16910 Datasheet, PDF (4/13 Pages) Maxim Integrated Products – 200mA, Automotive, Ultra-Low Quiescent Current, Linear Regulator

200mA, Automotive, Ultra-Low
Quiescent Current, Linear Regulator
ABSOLUTE MAXIMUM RATINGS
(All voltages referenced to GND.)
IN, ENABLE, SET.................................................. -0.3V to +45V
OUT, RESET (open-drain output)............................-0.3V to +12V
SETOV, TIMEOUT....................................................-0.3V to +6V
Maximum Current (all pins except IN and OUT)...............50mA
Continuous Power Dissipation (TA = +70°C)
8-Pin TDFN (derate 24.4mW/°C above +70°C)*.............1951mW
8-Pin SO (derate 23.3mW/°C above +70°C)*................1861mW
*As per JEDEC51 Standard (multilayer board).
Junction-to-Case Thermal Resistance (ΘJC) (Note 1)
8-Pin TDFN.......................................................................8°C/W
8-Pin SO...........................................................................7°C/W
Junction-to-Ambient Thermal Resistance (ΘJA) (Note 1)
8-Pin TDFN.....................................................................41°C/W
8-Pin SO.........................................................................43°C/W
Operating Temperature Range..........................-40°C to +125°C
Junction Temperature......................................................+150°C
Storage Temperature Range..............................-65°C to +150°C
Lead Temperature (soldering, 10s).................................+300°C
Note 1: Package thermal resistances were obtained using the method described in JEDEC specification JESD51-7, using a four-layer
board. For detailed information on package thermal considerations, refer to www.maxim-ic.com/thermal-tutorial.
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these
or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may
affect device reliability.
ELECTRICAL CHARACTERISTICS
(VIN = VENABLE = +14V, CTIMEOUT = open, CIN = 1μF, COUT = 4.7μF, unless otherwise noted. TA = TJ = -40°C to +125°C, unless
otherwise noted. Typical values are TA = +25°C.) (Note 2)
PARAMETER
Supply Voltage Range
Supply Current
Shutdown Supply Current
SYMBOL
VIN
ISHDN
CONDITIONS
Continuous
For P 400ms
ILOAD = 0, SET = GND, VOUT = 5V
ENABLE = GND, TA = +25NC
ENABLE = GND, -40NC P TA P +125NC
Output Voltage
(5V Fixed Output Setting)
VOUT50
1mA P ILOAD P 200mA,
VIN = 6V to 30V (Note 3)
Output Voltage
(3.3V Fixed Output Setting)
VOUT33
1mA P ILOAD P 200mA, VIN = 4.8V to 30V
(Note 3)
Adjustable Output-Voltage Range VOUT
SETOV FB Voltage
VSETOV ILOAD = 1mA
Dropout Voltage (Note 4)
DVDO
ILOAD = 200mA, SET = GND, SETOV =
HIGH, VOUT(NORM) = +5.0V
Short-Circuit Output Current Limit
ISC
Output shorted to GND (MAX16910C__)
Thermal Shutdown
(Note 5)
MIN TYP MAX UNITS
3.5
30
V
45
20
30
FA
1.6
3
FA
3
4.9
5.0
5.1
V
3.234 3.3 3.366
V
1.5
11.0
V
1.225 1.25 1.275
V
280 600
mV
230 330
mA
+180
NC
4   _______________________________________________________________________________________