MAX15006 Datasheet, PDF (3/15 Pages) Maxim Integrated Products – 40V, Ultra-Low Quiescent-Current Linear Regulators in 6-Pin TDFN/8-Pin SO

40V, Ultra-Low Quiescent-Current
Linear Regulators in 6-Pin TDFN/8-Pin SO
ELECTRICAL CHARACTERISTICS (continued)
(V_IN = 14V, I_OUT = 1mA, C_IN = 0.1µF, C_OUT = 2.2µF, T_A = T_J = -40°C to +125°C, unless otherwise noted. Typical specifications are
at T_A = +25°C.) (Note 1)
PARAMETER
SYMBOL
CONDITIONS
MIN TYP MAX UNITS
Output Current Limit
80
350
mA
Output Voltage Noise
100Hz to 100kHz, I_OUT ^VOUT ^{= 3.3V}
= 50mA, C_OUT = 2.2µF _{VOUT = 5V}
115
µV_RMS
179
Power-Supply Rejection Ratio PSRR f = 100Hz, V_{IN_RIPPLE} = 500mV_P-P, I_OUT = 50mA
66
dB
ENABLE LOGIC
Enable Threshold Voltage
V_IL
V_IH
Enable Threshold Hysteresis
0.4
V
1.4
60
mV
Enable Pulldown Current
Internally pulled down to GND
0.5
µA
Enable to Regulation Time
(Note 5)
0.4
2
ms
THERMAL SHUTDOWN
Thermal Shutdown
Thermal Shutdown Hysteresis
T_SHDN Junction temperature rising
T_HYST
+165
°C
20
°C
Note 1: Limits at -40°C are guaranteed by design.
Note 2: Output voltage regulation is guaranteed for I_OUT ≥ 5µA.
Note 3: Dropout voltage is defined as (V_IN - V_OUT) when V_OUT is 2% below the value of V_OUT when V_IN = V_OUT + 3V.
Note 4: For V_OUT = 3.3V, the 700mV dropout indicates V_OUT does not reach 2% below V_OUT at V_IN = V_OUT + 3V at minimum 4V
input voltage.
Note 5: Enable to regulation time is the time the output takes to reach 95% of its final value with V_IN = 14V and EN is taken from V_IL
to V_IH in 5ns.
_______________________________________________________________________________________ 3