DS1088L_12 Datasheet, PDF (3/8 Pages) Maxim Integrated Products – Fixed-Frequency EconOscillator™

DS1088L
Fixed-Frequency EconOscillator™
OSCILLATOR CHARACTERISTICS
(V_CC = 2.7V to 3.6V, T_A = -20NC to +85NC, unless otherwise noted.)
PARAMETER
SYMBOL
CONDITIONS
Output Frequency Range
Available
f_O
Output Frequency Tolerance
∆f_O
f_O
V_CC = 3.3V, T_A = +25NC (Note 2)
Voltage Frequency Variation
∆f_V
f_O
Over voltage range, T_A = +25NC (Note 3)
Temperature Frequency Variation
∆f_T
f_O
Over temperature
range, V_CC = 3.3V
(Notes 4, 5)
-20NC to +25NC
+25NC to +85NC
Frequency Variation Over
Voltage and Temperature
∆f_V,T
f_O
Over voltage and temperature range
MIN TYP
0.3124
-0.3
-0.35
-0.7
-0.5
-1.0
MAX UNITS
133.3 MHz
+0.3
%
+0.35
%
+0.7
%
+0.5
+1.0
%
AC ELECTRICAL CHARACTERISTICS
(V_CC = 2.7V to 3.6V, T_A = -20NC to +85NC, unless otherwise noted.)
PARAMETER
SYMBOL
CONDITIONS
MIN TYP MAX UNITS
Power-Up Time
t_POR +
t_STAB
(Note 6)
100
Fs
OUT Disabled After Entering
Power-Down Mode
t_PDN (Note 7)
7
Fs
Load Capacitance
Output Duty Cycle (OUT)
C_L
(Note 8)
f_O < 80MHz, f_O ≥ 80MHz
f_O < 80MHz
15
50
pF
40
60
%
50
Note 1: All voltages are referenced to ground.
Note 2: Typical frequency shift due to aging is within ±0.2%. Aging stressing includes level 1 moisture reflow preconditioning
(24hr +125°C bake, 168hr +85°C/85%RH moisture soak, and three solder reflow passes +240°C +0°C/-5°C peak) followed
by1000hr (max) V_CC biased +125°C OP/L, 1000hr unbiased +150°C bake, 1000 temperature cycles at -55°C to +125°C,
and 168hr +121°C/2 ATM steam/unbiased autoclave.
Note 3: This is the change in output frequency due to changes in voltage at T_A = +25°C.
Note 4: Guaranteed by design.
Note 5: This is the change in output frequency due to changes in temperature from the +25°C frequency at V_CC = 3.3V.
Note 6: This indicates the time elapsed between power-up and the output becoming active. An on-chip delay is intentionally intro-
duced to allow the oscillator to stabilize. t_STAB is equivalent to approximately 512 clock cycles and will depend on the pro-
grammed oscillator frequency.
Note 7: Output disabled in two cycles or less of the output frequency.
Note 8: Output voltage swings may be impaired at high frequencies combined with high-output loading.
����������������������������������������������������������������� Maxim Integrated Products  3