English
Language : 

MAX1589_07 Datasheet, PDF (2/12 Pages) Maxim Integrated Products – Low-Input-Voltage, 500mA LDO Regulator with RESETin SOT and TDFN
Low-Input-Voltage, 500mA LDO Regulator
with RESET in SOT and TDFN
ABSOLUTE MAXIMUM RATINGS
IN, SHDN, RESET to GND .....................................-0.3V to +4.0V
OUT to GND ................................................-0.3V to (VIN + 0.3V)
Output Short-Circuit Duration.....................................Continuous
Continuous Power Dissipation (TA = +70°C)
6-Pin Thin SOT23 (derate 9.1mW/°C above +70°C) ....727mW
6-Pin TDFN (derate 24.4mW/°C above +70°C) .........1951mW
Operating Temperature Range ...........................-40°C to +85°C
Junction Temperature ..................................................... +150°C
Storage Temperature Range .............................-65°C to +150°C
Lead Temperature (soldering, 10s) .................................+300°C
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
ELECTRICAL CHARACTERISTICS
(VIN = (VOUT + 0.5V) or VIN = 1.8V, whichever is greater; SHDN = IN, CIN = 1µF, COUT = 4.7µF, TA = -40°C to +85°C, unless other-
wise noted. Typical values are at TA = +25°C.) (Note 1)
PARAMETER
Input Voltage
Input Undervoltage Lockout
Output Voltage Accuracy
Maximum Output Current
Current Limit
Ground Current
Dropout Voltage
Load Regulation
Line Regulation
Output Noise
PSRR
SHUTDOWN
Shutdown Supply Current
SHDN Input Logic Levels
SHDN Input Bias Current
Turn-On Delay
RESET OUTPUT
Reset Threshold Accuracy
RESET Output Low Voltage
SYMBOL
CONDITIONS
VIN
VUVLO
VIN rising (180mV typical hysteresis)
IOUT = 150mA, TA = +25°C
IOUT = 1mA to 500mA,
VIN = (VOUT + 0.5V) to +3.6V
IOUT Continuous
ILIM
VOUT = 96% of nominal value
No load
IQ
IOUT = 500mA
Dropout (Note 2)
VIN - VOUT IOUT = 500mA, VOUT ≥ 1.8V (Note 2)
ΔVLDR IOUT = 1mA to 500mA
ΔVLNR
VIN = (VOUT + 0.5V) to +3.6V, IOUT = 100mA
10Hz to 100kHz, IOUT = 10mA
f < 1kHz, IOUT = 10mA
MIN TYP MAX UNITS
1.62
3.60
V
1.30
1.60
V
-0.5
+0.5
%
-1.5
+1.5
500
550
-0.15
850
70
90
70
175
0.02
+0.01
86
70
1150
140
350
0.5
+0.15
mARMS
mA
µA
mV
%
%/V
µVRMS
dB
IOFF
VIH
VIL
ISHDN
SHDN = GND
TA = +25°C
TA = +85°C
VIN = 1.62V to 3.6V
VIN = 1.62V to 3.6V
VSHDN = 0 or 3.6V
TA = +25°C
TA = +85°C
From SHDN high to OUT high, VOUT = 1.5V
0.001 1
µA
0.01
1.4
V
0.6
1
300
nA
5
90
µs
VOUT falling (1.7% typical hysteresis)
IRESET = 100µA
VOL
VIN = +1.0V, IRESET = 100µA
80 82.5 85 %VOUT
1.5 100
mV
3
100
2 _______________________________________________________________________________________