MAX11508 Datasheet, PDF (2/12 Pages) Maxim Integrated Products – Low-Cost, 3-Channel, HD/PS/SD/BP Video Filters with Buffer

Low-Cost, 3-Channel, HD/PS/SD/BP
Video Filters with Buffer
ABSOLUTE MAXIMUM RATINGS
V_CC to GND ..............................................................-0.3V to +6V
All Other Pins to GND...................................-0.3V to the lower of
(V_CC + 0.3V) and +6V
Continuous Power Dissipation (T_A = +70°C)
14-Pin TSSOP (derate 10mW/°C above +70°C) .......796.8mW
Maximum Current into Any Pin Except V_CC and GND .....±50mA
Operating Temperature Range…. ..........................0°C to +85°C
Storage Temperature Range .............................-65°C to +150°C
Lead Temperature (soldering, 10s) .................................+300°C
Junction Temperature ......................................................+150°C
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
ELECTRICAL CHARACTERISTICS
(V_CC = +5V, R_LOAD = 150Ω to GND, C_IN = 0.1µF, T_A = 0°C to +85°C, all frequency responses are relative to 100kHz, unless other-
wise noted.) (Note 1)
PARAMETER
SYMBOL
CONDITIONS
DC CHARACTERISTICS
Supply Current
Supply Voltage Range
I_CC No load
V_DD
Input Voltage Range
Power-Down Current
V_IN Referenced to GND if DC-coupled
BIAS = high
I_PD
BIAS = low
Digital Input High Voltage
V_IH
Digital Input Low Voltage
V_IL
STANDARD-DEFINITION VIDEO
-1dB Bandwidth
-3dB Bandwidth
f_1dB
MAX11508, T_A = +25°C
MAX11509, T_A = +25°C
MAX11508
f_3dB
MAX11509
Stopband Attenuation
A_SB f = 27MHz
Low-Frequency Gain
Differential Gain
A_V
No load
dG All channels
Differential Phase
dφ
All channels
Total Harmonic Distortion
THD V_OUT = 1.4V_P-P, f = 1MHz, all channels
Signal-to-Noise Ratio
SNR
2V_P-P signal to RMS noise,
f = 100kHz to 4.2MHz
MIN TYP MAX UNITS
24
35
mA
4.75 5.00 5.25
V
1.4
V
1
µA
15
2.0
V
0.8
V
4.5
7.9
5
8.6
MHz
9.0
MHz
10
35
48
dB
5.6
6.0
6.6
dB
0.7
%
0.7
Degrees
-60
dB
71
dB
Group Delay
Power-Supply Rejection Ratio
t_G
PSRR
f = 4.5MHz
DC, all channels
59
ns
50
dB
2 _______________________________________________________________________________________