English
Language : 

DS1080CL Datasheet, PDF (2/8 Pages) Maxim Integrated Products – Spread-Spectrum Crystal Multiplier
Spread-Spectrum Crystal Multiplier
ABSOLUTE MAXIMUM RATINGS
Voltage Range on VCC Relative to GND .............-0.5V to +3.63V
Voltage Range on Any Pin Relative
to GND ...............-0.5V to (VCC + 0.5V), not to exceed +3.63V
Continuous Power Dissipation (TA = +75°C)
µSOP (derate 4.5mW/°C above +70°C).......................362mW
Operating Temperature Range .........................-40°C to +125°C
Storage Temperature Range .............................-55°C to +125°C
Lead Temperature (soldering, 10s) .................................+300°C
Soldering Temperature (reflow) .......................................+260°C
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
RECOMMENDED OPERATING CONDITIONS
(TA = -40°C to +125°C, unless otherwise noted.)
PARAMETER
SYMBOL
CONDITIONS
Supply Voltage
VCC (Note 1)
Input Logic 1
VIH
Input Logic 0
Input Logic Open
Input Leakage
SSO Load
Crystal or Clock Input
Frequency
Crystal ESR
Clock Input Duty Cycle
Crystal Parallel Load
Capacitance
VIL
IIF
IIL
CSSO
fIN
XESR
FINDC
CL
0V < VIN < VCC (Note 2)
0V < VIN < VCC (Note 3)
(Note 4)
MIN
3.0
0.8 x
VCC
VGND -
0.3
8
40
TYP
MAX
3.6
VCC +
0.3
0.2 x
VCC
±1
±80
15
16
90
60
18
UNITS
V
V
V
μA
μA
pF
MHz

%
pF
DC ELECTRICAL CHARACTERISTICS
(VCC = +3.0V to +3.6V, TA = -40°C to +125°C, unless otherwise noted.)
PARAMETER
Supply Current
Power-Down Current
Output Leakage (SSO)
Low-Level Output Voltage
(SSO)
SYMBOL
ICC1
ICCQ
IOZ
CONDITIONS
CSSO = 15pF, fSSO = 8MHz
PDN = GND, all input pins open
PDN = GND
VOL
IOL = 4mA
High-Level Output Voltage
(SSO)
Input Capacitance (X1/X2)
VOH IOH = -4mA
CIN
(Note 5)
MIN
TYP
MAX UNITS
7
12
mA
200
μA
-1
+1
μA
0.4
V
2.4
V
5
pF
2 _______________________________________________________________________________________