DG528CJ Datasheet, PDF (2/12 Pages) Maxim Integrated Products – 8-Channel Latchable Multiplexers

8-Channel Latchable Multiplexers
ABSOLUTE MAXIMUM RATINGS
Voltage Referenced to V-
V+ ....................................................................................+44V
GND .................................................................................+25V
Digital Inputs V_S, V_{D .................................................}V- -2V to V+ +2V
or 20mA, whichever occurs first.
Current (any terminal, except S or D) .................................30mA
Continuous Current, S or D
Peak Current, S or D ...........................................................20mA
(pulsed at 1ms, 10% duty cycle max) ............................50mA
Continuous Power Dissipation (TA = +70°C) (Note 1)
18-Pin Plastic DIP (derate 11.11mW/°C above +70°C)...889mW
18-Pin Wide SO (derate 9.52mW/°C above +70°C) ....762mW
18-Pin CERDIP (derate 10.53mW/°C above +70°C)....842mW
20-Pin PLCC (derate 10.00mW/°C above +70°C) .......800mW
20-Pin LCC (derate 9.09mW/°C above +70°C) ...........727mW
Operating Temperature Ranges
DG52_C_ ............................................................0°C to +70°C
DG52_D_/E_ ....................................................-40°C to +85°C
DG52_A_ .......................................................-55°C to +125°C
Storage Temperature Range .............................-65°C to +150°C
Lead Temperature (soldering, 10sec) .............................+300°C
Note 1: All leads are soldered or welded to PC board.
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
ELECTRICAL CHARACTERISTICS
(V+ = 15V, V- = -15V, VEN = 2.4V, WR = 0V, RS = 2.4V, TA = TMIN to TMAX, unless otherwise noted.)
PARAMETER
SWITCH
Analog-Signal Range
Drain-Source
On-Resistance
SYMBOL
CONDITIONS
DG52_A
MIN TYP MAX
DG52_C/D/E
MIN TYP MAX
UNITS
VANALOG (Note 2)
-15
15 -15
15
V
V_D = ±10V, V_AL = 0.8V,
rDS(ON) IS = -200µA, VAH = 2.4
(Note 3)
TA = +25°C,
TMIN
TA = TMAX
270 400
500
270 450
Ω
500
Greatest Change in Drain-
Source On-Resistance ∆r_DS(ON) -10V < V_S < 10V
TA = +25°C
6
Between Channels
6
%
Source-Off Leakage
Current
Drain-Off Leakage
Current
Drain-On Leakage
Current (Notes 3, 4)
INPUT
Address Input Current,
Input Voltage High
Address Input Current,
Input Voltage Low
IS(OFF)
VEN = 0V, VS = ±10V,
VD = ±10V
TA = +25°C -1 -0.005 1 -5 -0.005 5
TA = TMAX -50 -0.005 50 -50 -0.005 50
nA
ID(OFF)
VEN = 0V,
VS = ±10V,
VD = ±10V
DG528 ^{TA = +25°C -10 -0.015 10 -20 -0.015 20}
TA = TMAX -200 -0.015 200 -200 -0.015 200 _nA
DG529 ^{TA = +25°C -10 -0.008 10 -20 -0.008 20}
TA = TMAX -100 -0.008 100 -100 -0.008 100
VAH = 2.4V,
DG528 ^{TA = +25°C -10 -0.03 10 -20 -0.03 20}
ID(ON)
VS = VD = ±10V,
VAL = 0.8V,
VEN = 2.4V
DG529
TA = TMAX
TA = +25°C
TA = TMAX
-200
-10
-100
-0.03
-0.015
-0.015
200 -200 -0.03
10 -20 -0.015
100 -100 -0.015
200
20
100
nA
VA = 2.4V
IAH
VA = 15V
IAL
VA = RS = WR = 0V,
VEN = 0V or 2.4V
TA = +25°C -1 -0.002 1 -1 -0.002 1
TA = TMAX -30
-30
µA
TA = +25°C -1 -0.006 1 -1 -0.006 1
TA = TMAX
30
30
TA = +25°C -1 -0.002 1 -1 -0.002 1
µA
TA = TMAX -30 -0.01
-30 -0.01
2 _______________________________________________________________________________________