MAX9930_09 Datasheet, PDF (13/16 Pages) Maxim Integrated Products – 2MHz to 1.6GHz 45dB RF-Detecting Controllers and RF Detector

2MHz to 1.6GHz 45dB RF-Detecting
Controllers and RF Detector
Filter Capacitor and Transient Response
In general, for the MAX9930/MAX9931/MAX9932, the
choice of filter capacitor only partially determines the
time-domain response of a PA control loop. However,
some simple conventions can be applied to affect tran-
sient response. A large filter capacitor, C_CLPF, domi-
nates time-domain response, but the loop bandwidth
remains a factor of the PA gain-control range. The
bandwidth is maximized at power outputs near the cen-
ter of the PA’s range, and minimized at the low and
high power levels, where the slope of the gain-control
curve is lowest.
A smaller valued C_CLPF results in an increased loop
bandwidth inversely proportional to the capacitor value.
Inherent phase lag in the PA’s control path, usually
caused by parasitics at OUT, ultimately results in the
addition of complex poles in the AC loop equation. To
avoid this secondary effect, experimentally determine
the lowest usable C_CLPF for the power amplifier of inter-
est. This requires full consideration to the intricacies of
the PA control function. The worst-case condition,
where the PA output is smallest (gain function is steep-
est) should be used because the PA control function is
typically nonlinear. An additional zero can be added to
improve loop dynamics by placing a resistor in series
with C_CLPF. See Figure 4 for the gain and phase
response for different C_CLPF values.
Additional Input Coupling
There are three common methods for input coupling:
broadband resistive, narrowband reactive, and series
attenuation. A broadband resistive match is implement-
ed by connecting a resistor to ground at the external
AC-coupling capacitor at RFIN as shown in Figure 5. A
50Ω resistor (use other values for different input imped-
ances) in this configuration, in parallel with the input
impedance of the MAX9930–MAX9933, presents an
input impedance of approximately 50Ω. These devices
require an additional external coupling capacitor in
series with the RF input. As the operating frequency
increases over 2GHz, input impedance is reduced,
resulting in the need for a larger-valued shunt resistor.
Use a Smith Chart for calculating the ideal shunt resis-
tor value. Refer to the MAX4000/MAX4001/MAX4002
data sheet for narrowband reactive and series attenua-
tion input coupling.
50Ω SOURCE
50Ω
C_C
RFIN
R_S
50Ω
MAX9930
MAX9931
MAX9932
MAX9933
C_IN
R_IN
V_CC
Figure 5. Broadband Resistive Matching
GAIN AND PHASE vs. FREQUENCY
80
180 ^{MAX9930 fig04}
60 ^GAIN
C_CLPF = 2000pF
135
40
20 _{CCLPF = 200pF}
90
C_CLPF = 200pF ₄₅
0
0
-20
-45
-40
-90
C_CLPF = 2000pF
-60
-135
-80
-180
PHASE
-100
-225
10 100 1k 10k 100k 1M 10M 100M
FREQUENCY (Hz)
Figure 4. Gain and Phase vs. Frequency
SMALL-SIGNAL BANDWIDTH vs. C_CLPF
10
1
0.1
0.01
100
1000
10,000
C_CLPF (pF)
100,000
______________________________________________________________________________________ 13