MAX1584 Datasheet, PDF (11/29 Pages) Maxim Integrated Products – 5-Channel Slim DSC Power Supplies

5-Channel Slim DSC Power Supplies
Pin Description (continued)
PIN
NAME
FUNCTION
16
AUX1OK ^{Open-Drain Power-OK Signal for AUX1 Controller. AUX1OK is low when the AUX1 controller has}
successfully completed soft-start. This pin is high impedance in shutdown, overload, and thermal limit.
17
SDOK
Open-Drain Power-OK Signal for Step-Down Converter. SDOK is low when the step-down has successfully
completed soft-start. This pin is high impedance in shutdown, overload, and thermal limit.
Short-Circuit Flag, Active-Low, Open-Drain Output. SCF is high impedance when overload protection
18
SCF
occurs and during startup. SCF can drive high-side PFET switches connected to one or more outputs to
completely disconnect the load when the channel turns off in response to a logic command or an
overload. See the Status Outputs (SDOK, AUX1OK, SCF) section.
Oscillator Control. Connect a timing capacitor from OSC to GND and a timing resistor from OSC to PVSU
19
OSC
(or other DC voltage) to set the oscillator frequency between 100kHz and 1MHz. See the Setting the
Switching Frequency section. This pin is high impedance in shutdown.
20
PGSU
Step-Up Power Ground. Connect all PG_ pins together and to GND with short traces as close to the IC as
possible.
21
LXSU
Step-Up Converter Switching Node. Connect to the inductor of the step-up converter. LXSU is high
impedance in shutdown.
22
PVSU
Power Output of the Step-Up DC-DC Converter. Connect the output filter capacitor from PVSU to PGSU.
PVSU can also power other converter channels. Connect PVSU to PV at the IC.
MAX1585 (AUX2 inverter): The FB2 feedback threshold is 0V.
Connect a resistive voltage-divider from the output voltage to FB2 to
AUX2 Controller Feedback Input. _{REF to set the output voltage.}
23
FB2
This pin is high impedance in
shutdown.
MAX1584 (AUX2 step-up): The FB2 feedback threshold is 1.25V.
Connect a resistive voltage-divider from the output voltage to FB2 to
GND to set the output voltage.
AUX2 Controller Compensation Node. Connect a series resistor-capacitor from CC2 to GND to
24
CC2
compensate the control loop. CC2 is actively driven to GND in shutdown and thermal limit. See the AUX
Compensation section.
MAX1585 (AUX2 inverter): Connect INDL2 to the external P channel
Voltage Input for the AUX2 Gate ^{MOSFET source (typically the battery) to ensure the P channel is}
25
INDL2 Driver. The voltage at INDL2 sets ^{completely off when D2 swings high.}
the high gate-drive voltage.
MAX1584 (AUX2 step-up): Connect INDL2 to PVSU for optimum
N-channel gate drive.
26
PV
IC Power Input. Connect PVSU and PV together.
MAX1585: DL2 drives a PFET in an inverter configuration. In
AUX2 Controller Gate-Drive
shutdown, overload, and thermal limit, DL2 is driven high.
27
DL2
Output. DL2 drives between
MAX1584: DL2 drives an N-channel FET in a boost/flyback
INDL2 and GND.
configuration. In shutdown, overload, and thermal limit, DL2 is driven
low.
______________________________________________________________________________________ 11