|
MAX9982_1 Datasheet, PDF (1/7 Pages) Maxim Integrated Products – Evaluation Kit | |||
|
19-2693; Rev 1; 1/04
MAX9982 Evaluation Kit
General Description
The MAX9982 evaluation kit (EV kit) simplifies the evalu-
ation of the MAX9982 825MHz to 915MHz high-linearity
active down-converter mixer. It is fully assembled and
tested at the factory. Standard 50⦠SMA connectors
are included on the EV kit for the inputs and outputs to
allow quick and easy evaluation on the test bench.
This document provides a list of equipment required to
evaluate the device, a straightforward test procedure to
verify functionality, a description of the EV kit circuit, the
circuit schematic, a bill of materials (BOM) for the kit,
and artwork for each layer of the PC board.
Contact MaximDirect sales at 888-629-4642 to check
on pricing and availability for these kits.
Features
⦠Fully Assembled and Tested
⦠+26.8dBm Input IP3
⦠+13dBm Input 1dB Compression Point
⦠825MHz to 915MHz RF Frequency
⦠725MHz to 1085MHz LO Frequency
⦠70MHz to 170MHz IF Frequency
⦠2dB Conversion Gain
⦠12dB Noise Figure
⦠-5dBm to +5dBm LO Drive
⦠Built-In LO Switch with 43dB LO1-to-LO2 Isolation
Component Suppliers
SUPPLIER
Coilcraft
Digi-Key
Johnson
Mini-Circuits
Murata
PHONE
WEBSITE
800-322-2645 www.coilcraft.com
800-344-4539 www.digikey.com
507-833-8822 www.johnsoncomponents.com
718-934-4500 www.minicircuits.com
770-436-1300 www.murata.com
Ordering Information
PART
TEMP RANGE
MAX9982EVKIT
-40°C to +85°C
*EP = Exposed paddle.
IC PACKAGE
Thin QFN 20-EP*
(5mm â 5mm)
Component List
DESIGNATION
C1, C2, C6, C7
C3
C4, C5
C8, C11
C9, C10
L1, L2
QTY
4
1
2
2
2
2
DESCRIPTION
33pF ±5%, 50V C0G ceramic
capacitors (0603)
Murata GRM1885C1H330J
0.033µF ±10%, 25V X7R ceramic
capacitor (0603)
Murata GRM188R71E333K
0.1µF ±10%, 16V X7R ceramic
capacitors (0603)
Murata GRM188R71C104K
220pF ±5%, 50V C0G ceramic
capacitors (0603)
Murata GRM1885C1H221J
330pF ±5%, 50V C0G ceramic
capacitors (0603)
Murata GRM1885C1H331J
560nH ±5% wire-wound inductors
(1008)
Coilcraft 1008CS-561XJBC
DESIGNATION QTY
DESCRIPTION
R1
1 249⦠±1% resistor (0603)
R3, R4
R5
1 137⦠±1% resistors (0603)
1 47k⦠±5% resistor (0603)
J1âJ4
PC board edge-mount SMA RF
4 connectors (flat tab launch)
Johnson 142-0741-856
T1
1
4:1 transformer (200:50)
Mini-Circuits TC4-1W-7A
TP1
1
Large test point for 0.062in PC board
(red) Mouser 151-107
TP2
1 Large test point for 0.062in PC board
(black) Mouser 151-103
TP3
1
Large test point for 0.062in PC board
(white) Mouser 151-101
U1
1 MAX9982ETP-T*
*The exposed paddle conductor on U1 must be solder
attached to a grounded pad on the circuit board to ensure a
proper electrical/thermal design.
________________________________________________________________ Maxim Integrated Products 1
For pricing, delivery, and ordering information, please contact Maxim/Dallas Direct! at
1-888-629-4642, or visit Maximâs website at www.maxim-ic.com.
|
▷ |