MAX17523EVKIT Datasheet, PDF (1/10 Pages) Maxim Integrated Products – 4.5V to 36V Operating Voltage Range

MAX17523 Evaluation Kit
Evaluates: MAX17523
General Description
The MAX17523 evaluation kit (EV kit) is a fully assembled
and tested circuit board that demonstrates the MAX17523
adjustable overcurrent and overvoltage protector. The
EV kit features TVS diode on input and Schottky diode
on output. Input power to the EV kit uses a 4.5V to 36V
input supply.
The EV kit circuit can be configured to demonstrate the
device’s different current-limit types, adjustable overvoltage,
undervoltage, and current-limit threshold.
Features
● 4.5V to 36V Operating Voltage Range
● Features TVS Diode and Schottky Diode
● Evaluates Three Current-Limit Types,
Current-Limit Threshold, OVLO, and UVLO
● Proven PCB Layout
● Fully Assembled and Tested
Ordering Information appears at end of data sheet.
Quick Start
Required Equipment
● MAX17523 EV kit
● 36V DC power supply
● Multimeter
● USB-A male to USB-B male cable or
5V DC power supply
Procedure
The EV kit is fully assembled and tested. Follow the steps
below to verify board operation:
1) Verify that all jumpers are in their default positions.
2) Connect the USB cable to J1 from a computer or
connect a 5V DC power supply to TP3.
3) Verify that LED1 is on.
4) Connect a 20V DC power supply to IN. Verify that
OUT is 20V.
5) Increase voltage on the DC power supply and verify
that the OUT voltage goes down and FLAG goes low
when input reaches approximately 33V.
6) Decrease voltage on the DC power supply and verify
that OUT goes back and FLAG goes high when the
input reaches approximately 32V.
19-8511; Rev 0; 12/16