|
MAX14585 Datasheet, PDF (1/12 Pages) Maxim Integrated Products – Hi-Speed USB and Audio Switches with Negative Signal Capability and High-Voltage-Tolerable | |||
|
19-5878; Rev 0; 5/11
EVALUATION KIT AVAILABLE
MAX14585/MAX14585A
Hi-Speed USB and Audio Switches with Negative Signal
Capability and High-Voltage-Tolerable VBUS Detection
General Description
Benefits and Features
The MAX14585/MAX14585A high-ESD-protected double-
pole/double-throw (DPDT) switches multiplex Hi-Speed
(480Mbps) USB and analog signals such as AC-coupled
audio or video. These devices combine the low on-
capacitance (CON) and low on-resistance (RON) neces-
sary for high-performance switching applications in por-
table electronics and include an internal negative supply
to pass audio signals that swing below ground down to
-1.8V. The devices also handle USB low-/full-speed sig-
naling and operate from a 2.7V to 5.5V supply.
The devices feature a VBUS detection input (VB) that can
handle voltage up to 28V to automatically switch to the
USB signal path upon detection of a valid VBUS signal (VB
> VVBDET). In a dead battery situation, the voltage on VB
can supply power to the part if VB is greater than 4.5V. The
MAX14585 features internal shunt resistors on the audio
path to reduce clicks and pops heard at the output.
The MAX14585/MAX14585A are available in a space-
saving, 10-pin, 1.4mm x 1.8mm UTQFN package and
operate over the -40NC to +85NC temperature range.
Applications
Cell Phones
PDAs and Handheld Devices
Tablet PCs
S Low Power Consumption
ï² Low Supply Current 7µA (typ)
ï² Single 2.7V to 5.5V Supply Operation, VCC
S Flexible Design
ï² Dual Power-Supply Architecture, VB and VCC
ï² ANO_ Channel Override Control Input
S High Level of Integration for Performance
ï² 28V-Capable VB Input with Automatic UNC_
Selection by VBUS Detection
ï² Low-Capacitance Hi-Speed USB for Both
Channels (UNC_ and ANO_)
ï² Distortion-Free Negative Signal Throughput
Down to -1.8V on ANO_ Channel
ï² 3I (typ) On-Resistance
ï² 960MHz Bandwidth
ï² 0.04% THD+N Audio Channel
ï² Â±15kV Human Body Model (HBM) ESD on
COM1, COM2
S Saves Board Space
ï² Internal Shunt Resistor Reduces Clicks and
Pops (MAX14585)
ï² 10-Pin, 1.4mm x 1.8mm UTQFN Package
Ordering Information appears at end of data sheet.
For related parts and recommended products to use with this part,
refer to www.maxim-ic.com/MAX14585.related.
Typical Operating Circuit
HI-SPEED
USB
TRANSCEIVER
UNC1
UNC2
3.0V 0.1µF
VCC
MAX14585/MAX14585A
VCCINT
AN01
AUDIO
AMPLIFIER
AN02
COM1
COM2
COMBINATION
USB AND AUDIO
CONNECTOR
MAX14585
ONLY
VB
VVBDET
VBUS
GND
AOR
����������������������������������������������������������������� Maxim Integrated Productsââ 1
For pricing, delivery, and ordering information, please contact Maxim Direct at 1-888-629-4642,
or visit Maximâs website at www.maxim-ic.com.
|
▷ |