|
DS28E04-100 Datasheet, PDF (1/37 Pages) Dallas Semiconductor – 4096-Bit Addressable 1-Wire EEPROM with PIO | |||
|
19-6134; Rev 12/11
DS28E04-100
4096-Bit Addressable 1-Wire EEPROM with PIO
GENERAL DESCRIPTION
The DS28E04-100 is a 4096-bit, 1-Wire® EEPROM
chip with seven address inputs. The address inputs
are directly mapped into the 1-Wire 64-bit Device ID
Number to easily enable the host system to identify
the physical location or functional association of the
DS28E04-100 in a multidevice 1-Wire network en-
vironment. The 4096-bit EEPROM array is configured
as 16 pages of 32 bytes with a 32 byte scratchpad to
perform write operations. EEPROM memory pages
can be individually write protected or put in EPROM-
emulation mode, where bits can only be changed
from a 1 to a 0 state. In addition to the memory, the
DS28E04-100 has two general-purpose I/O ports that
can be used for input or to generate level and/or
pulse outputs. Activity registers also capture port
activity for state change monitoring. The DS28E04-
100 communicates over the single-contact 1-Wire
bus. The communication follows the standard Maxim
1-Wire protocol.
APPLICATIONS
Autoconfiguration of Modular Systems such as
Central-Office Switches, Cellular Base Stations,
Access Products, Optical Network Units, and
PBXs
Accessory/PCB Identification
TYPICAL OPERATING CIRCUIT
VCC
RPUP
FEATURES
⢠4096 bits of EEPROM Memory Partitioned into
16 Pages of 256 Bits
⢠Seven Address Inputs for Physical Location
Configuration
⢠Two General-Purpose PIO Pins with Pulse-
Generation Capability
ï§ Individual Memory Pages can be Permanently
Write-Protected or put in OTP EPROM-
Emulation Mode (âWrite to 0â)
ï§ Communicates to Host with a Single Digital
Signal at 15.3kbps or 111kbps Using 1-Wire
Protocol
ï§ Parasitic or VCC Powered
ï§ Conditional Search Based on PIO Status or PIO
Activity
ï§ Switchpoint Hysteresis and Filtering to Optimize
Performance in the Presence of Noise
ï§ Reads and Writes Over a Wide 2.8V to 5.25V
Voltage Range from -40°C to +85°C
ï§ 16-Pin, 150-mil SO Package
ORDERING INFORMATION
PART
TEMP RANGE PIN-PACKAGE
DS28E04S-100+ -40°C to +85°C 16 SO
DS28E04S-100+T
-40°C to +85°C
16 SO
(2.5k pieces)
+ Indicates lead(Pb)-free/RoHS-compliant package.
T = Tape and reel.
PIN CONFIGURATION
PX.Y
µC
LED
IO VCC A6
POL
P1
P0
GND A0
DS28E04 #1
IO VCC A6
POL
P1
P0
GND A0
RST1 RST0 DS28E04 #7
SO (150 mils)
Commands, Registers, and Modes are capitalized for
clarity.
1-Wire is a registered trademark of Maxim Integrated Products, Inc.
1 of 37
|
▷ |