88SE9128 Datasheet, PDF (1/2 Pages) –

Marvell 88SE9128/9120/9125/9111/9110
SATA 6Gb/s RAID Controllers
PRODUCT OVERVIEW
The Marvell^® 88SE91xx host controllers offer cost-effective solutions for connecting Serial ATA (SATA) or Parallel
ATA (PATA) peripherals to a PCI Express (PCIe) 2.0 host. Each host controller supports one or more 6 Gb/s SATA
and one 133 MB/s PATA peripheral interface ports and a one-lane PCIe 2.0 host interface. In addition, it features
advanced hardware encryption to protect user data on the fly and hardware RAID to offload the host CPU. A
complete suite of RAID 0/1 software is provided, including the OS device driver, BIOS/FW, and a management
utility. RAID 5/10 is also available as an option when the 88SE91xx is connected with a SATA port multiplier.
SATA 6 Gb/s
AES 256
PATA
TWSI
NCQ
PM Control
/FBS
Enclosure
Mgmt
Flash
HW RAID 0/1
GPIO
(LEDs)
Dual Configuration
PCIe 2.0 x1
OSC
MODEL
• Marvell RAID Software
• 6 Gb/s SATA Ports
• One 133 MBps PATA Port
• SATA 3.0 Compliant
• PCIe 2.0 Compliant
• Native Command Queuing
• eSATA Support
• Hardware RAID
• Hardware Encryption
• Enclosure Management
• Two-Wire Serial Interface (TWSI)
• GPIO Support
• SPI Flash Interface
• Port Multiplier Support
• FIS-Based Switching
• On-Chip Oscillator
• Power
• Package Size/Type
*support customer’s own RAID software
Fig 1. Block Diagram
88SE9128
88SE9120
88SE9125
88SE9111/9110
Yes
Non-RAID
N/A*
Non-RAID
2
2
2
1
Enhanced mode with ATAPI protocol support
6 Gb/s SATA PHY with speed negotiation to backward support 3 and 1.5 Gb/s
Support 1x PCI Express 2.0 interface (5.0 GT/s)
32 outstanding commands per port for high performance
Flexible SATA ports support internal or external (up to 5m) SATA links
Yes
No
Yes
No
128/256-bit AES
No
Yes
Yes/No
I2C support
Interface for external EEPROM containing configuration information
LEDs status monitoring
External flash containing configuration data and/or boot code
RAID support through Marvell RAID utility (MRU) and driver
Better performance with simultaneous commands
Low-cost crystal support
1W
0.9W
1W
0.6W
9mm×9mm / 76-pin QFN