100044 Datasheet, PDF (1/1 Pages) Marl International Limited – DISCRETE LEDs - Ø 3mm BLUE

Anode
1.5 max
3.5
2.0
Dimensions in mm (Typical)
Tolerance +/- 0.2 UOS
Not to Scale
1.0
5.0
6.0
11.0+/-0.5
27.5+/-1
DISCRETE LEDs - Ø 3mm BLUE
• ^{High intensity}
• ^{Also available as a}
5mm device
• ^{Solid state reliability}
• ^{Can be supplied in}
bulb replacement and
panel mounting
formats
100044 SERIES
Ordering Information & Typical Technical Characteristics (Ta = 25°C)
* Duty Cycle <= 1/10, Pulse Width <= 10msec
PART
NUMBER
100044
UNITS
COLOUR
TYP. FWD
VOLTAGE
Vf@lopr
MAX FWD
VOLTAGE
Vf@lopr
FORWARD
CURRENT
lopr
MAX REV
CURRENT
lr(Vr=5V)
TYPICAL LUMINOUS
INTENSITY
lv@lopr
TYPICAL CHROMATICITY
COORDINATES
@lopr
VIEWING
ANGLE
2ø½
OPTICAL/ELECTRIC_SA_TAL_NDC_AH_RDAR_INA_TEC_NT_SIE_TYRISTICS (Ta = 25°C)
Blue
3.6
4.0
20
50
2300
0.13 / 0.075
15
Water Clear V
V
mA
uA
mcd
x/y
deg
PART
NUMBER
100044
UNITS
COLOUR
Blue
Water Clear
FORWARD
CURRENT
lopr max
30
mA
PEAK FWD
CURRENT
lfp *
REVERSE
VOLTAGE
Vr max
POWER
DOM
DISSIPATION WAVELENGTH
P dmax
Typ. λd
ABSOLUTE MAXIMUM RATINGS (Ta = 25°C)
STANDARD INTENSITY
100
5
120
470
mA
Vdc
mW
nm
OPERATING
TEMP
Topr
-30 to +85
°C
STORAGE
TEMP
Tstg
-40 to +100
°C
PRECAUTIONS FOR HANDLING ELECTROSTATIC SENSITIVE LEDs
Static Electricity and Surge
Static electricity and surge will damage the LED and a high standard of care must be taken during handling. It is recommended
that a wristband, conductive mat or anti-electrostatic glove is used when handling the LEDs. All devices, equipment (e.g.
soldering iron points) and machinery must be properly grounded.
SAFETY PRECAUTIONS FOR HANDLING HIGH BRIGHTNESS LEDs
The light output of the Products may cause injuries to human eyes in circumstances where they are viewed directly with
unshielded eyes for more than a few seconds.
Please refer to European Standard BSEN 100015-1 1992 for further information.
© MARL OPTOSOURCE 2006 : DS 100044 Issue 1
Telephone [phone] _• Fax: [phone] _• email: [e-mail] _• website: www.optosource.com
The information contained in this datasheet does not constitute part of any order or contract and should not be regarded as a representation relating to
either products or service. Marl International reserve the right to alter without notice the specification or any conditions of supply for products or service.