MTB10000-UR-A Datasheet, PDF (6/6 Pages) Marktech Corporate – 10 SEGMENT LIGHT BAR

MTB10000-UR-A
10 SEGMENT
LIGHT BAR
Precautions in Use:
PLEASE PAY SPECIAL ATTNTION TO THE NEXT POINT TO INCORPORATE OPTO
DEVICE TO HIGH RELIABILITY
1. Do not bend the lead. Bending leads could cause breakage of leads or the degradation of the chip.
When bending is unavoidable, strictly follow the cautionary instruction below.
(1)Bend the leads before soldering.
(2)Bending a lead must be done by fixing a lead tightly and applying no stress on the resin part.
(3) The lead bending point must be more than 1.6mm away from the edge or the resin part.
(4)When a pin is tested for its endurance, bending degree should be ∘BOE
repeated no more than two times.
2. Setting a product by using tool such as a holder should be avoided.
When necessary, no stress should be applied to the resin part and lead to consider dimension tolerance,
thermal expansion, thermal contraction of holder, product and circuit board etc.
3. The hole pitch of a circuit board must fit into the lead pitch of products.
4. When soldering, care the followings:
(1)Do not heat a product under any stress (i.e.: twist) to leads.
(2)Do not heat ( for example, by soldering ) a product while out side force is applied the resin part.
(3 The lead bending point must be more than 1.6mm away from the edge or the resin part.
(4)Soldering with PC Board should be conducted with following conditions.
(a) For dip soldering
Pre-heating : 90Ċ Max. for within 60 Sec.
Soldering Max. : 260Ô5Ċ(Solder Temp.) for within 5 Sec.
(b) Soldering iron : 350Ċ 4PMEFSJOH
JSPO
UJQ
GPS
XJUIJO

4FD




'MVY
DPVME
DPSSPEF
UIF
MFBET6TF
GMVY
UIBU
DPOUBJOT
BT
MJUUMF
DIMPSJOF
BT
QPTTJCMF
3"
3."






MFTT
UIBO

XU
BOE
OFFE
OPU
CF
XBTIFE
XBZ

8IFO
IPXFWFS
XBTIJOH
JT
OFDFTTBSZ
QBSUJBMMZ
XBTI







BSPVOE
UIF
MFBET
JOTUFBE
PG
UIF
FOUJSF
-&%
CZ
UIF
GPMMPXJOH
DPOEJUJPOT






$MFBOJOH

BHFOU


.FUIZM
"MDPIPM






$MFBOJOH

UFNQ



ĊMax.
Cleaning time : 30Sec. Max.
6. Minimum amount of soldering flux should be used. Soldering flux should be applied only to the pin portion.
7. The following may damage products or LED chips: Attachment or contact of residual flux solvent
onto the product surface or to LED chips, or invasion of the same into the product.
VER.: 01 Date: 2007/10/04 Page: 5/5