MTSM365UV-D5120 Datasheet, PDF (5/9 Pages) Marktech Corporate – Super high power output

Reflow Soldering Profile
Ultraviolet Emitter
Product No: MTSM365UV-D5120
Profile Feature
Sn-Pb Eutectic Assembly Pb-Free Assembly
Average ramp-up rate (Ts_max to Tp) 3° C/second max.
3° C/second max.
Preheat
- Temperature Min (Ts_min)
- Temperature Max (Ts_max)
- Time (Ts_min to Ts_max) (ts)
100 °C
150 °C
60-120 seconds
150 °C
200 °C
60-180 seconds
Time maintained above:
- Temperature (TL)
- Time (tL)
Peak Temperature (Tp)
Time within 5°C of actual Peak
Temperature (t)2
Ramp-down Rate
Time 25°C to Peak Temperature
183 °C
60-150 seconds
215℃
10-30 seconds
6 °C/second max.
6 minutes max.
217 °C
60-150 seconds
260℃
20-40 seconds
6 °C/second max.
8 minutes max.
* Caution
1. Reflow soldering should not be done more than one time.
2. Repairs should not be done after the LEDs have been soldered. When
repair is unavoidable, suitable tools must be used.
3. Die slug is to be soldered.
4. When soldering, do not put stress on the LEDs during heating.
5. After soldering, do not warp the circuit board.
6. Recommend to use a convection type reflow machine with 7 ~ 8 zones.
The information contained herein is subject to change without notice.
Global Headquarters, 3 Northway Lane North, Latham, NY 12110, USA www.marktechopto.com
TOLL FREE: 1-800-984-5337 • PHONE: [phone] • FAX: [phone] • EMAIL: [e-mail]
2016-10-14
5