EZ600_15 Datasheet, PDF (2/5 Pages) Marktech Corporate – Gen II LED

Maximum Ratings at T_A = 25°C ^{Note 1}
DC Forward Current
Peak Forward Current
LED Junction Temperature
Reverse Voltage
Operating Temperature Range
Storage Temperature Range
CxxxEZ600-Sxx000-2
400 mA
600 mA ^{Note 3}
145°C
5V
-40°C to +100°C
-40°C to +120°C
Typical Electrical/Optical Characteristics at T_A = 25°C, If = 350 mA ^{Note 2}
Part Number
Forward Voltage (V_f, V)
C450EZ600-Sxx00-2
C460EZ600-Sxx00-2
C527EZ600-Sxx00-2
Min.
3.1
3.1
3.1
Typ.
3.5
3.5
3.5
Max.
4.1
4.1
4.1
Reverse Current
[I(Vr=5 V), μA]
Max.
2
2
2
Full Width Half Max
(λ_D, nm)
Typ.
20
21
35
Mechanical Specifications
Description
P-N Junction Area (μm)
Chip Area (μm)
Chip Thickness (μm)
Top Au Bond Pad (μm)
Au Bond Pad Thickness (μm)
Back Contact Metal Area (μm)
Back Contact Metal Thickness (μm)
CxxxEZ600-Sxx000-2
Dimension
Tolerance
550 x 550
±40
580 x 580
±40
170
±25
130 x 130
±15
3.0
±1.0
580 x 580
±40
3.0
±1.0
Notes:
1. Maximum ratings are package-dependent. The above ratings were determined using a Au-plated TO39 header without an
encapsulant for characterization. Ratings for other packages may differ. The junction temperature should be characterized in a
specific package to determine limitations. Assembly processing temperature must not exceed 325°C (< 5 seconds). See Cree
EZBright Applications Note for assembly-process information.
2. All products conform to the listed minimum and maximum specifications for electrical and optical characteristics when assembled
and operated at 350 mA within the maximum ratings shown above. Efficiency decreases at higher currents. Typical values
given are within the range of average expected by the manufacturer in large quantities and are provided for information only.
All measurements were made using a Au-plated TO39 header without an encapsulant. Optical characteristics measured in an
integrating sphere using Illuminance E.
3. This peak forward current specification is based on a 400 ms pulse width at a 1/5-duty cycle with a junction temperature of 65°C.
4. Specifications are subject to change without notice.
Copyright © 2010 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree and the
Cree logo are registered trademarks, and EZBright, EZ, and EZ600 are trademarks of Cree, Inc.
2
CPR3EE Rev. A
Cree, Inc.
4600 Silicon Drive
Durham, NC 27703
USA Tel: [phone]
www.cree.com