PN6530 Datasheet, PDF (8/20 Pages) Mallory performance club – Programmable 6AL-2 Ignition Control

8
CONDENSER
PN 8861
INSTALLATION INSTRUCTIONS
NOTE: The GM Ignition Module
is removed and replaced
with the MSD PN 8861
Wire Harness.
MAP
SENSOR
VIOLET
GREEN
LAUNCH
(12V TO ACTIVATE)
BURNOUT
(12V TO ACTIVATE)
DARK BLUE
LIGHT BLUE
RETARD ^PINK
(12V TO ACTIVATE)
RED
TO 12V
IGNITION KEY
PN 8860 HARNESS
TACH OUTPUT
GRAY
RED
HALL-EFFECT
(NOT USED)
WHITE
(NOT USED)
COVER WITH TAPE
WHITE/BLUE
WHITE
HEAVY RED
TO BATTERY
HEAVY BLACK
TO BATTERY
Figure 7 Wiring the Programmable 6AL-2 with an HEI 4-pin Module (Magnetic Pickup Trigger).
VIOLET
MAGNETIC PICKUP
(NOT USED) _GREEN
LAUNCH
(12V TO ACTIVATE)
BURNOUT
(12V TO ACTIVATE)
DARK BLUE
LIGHT BLUE
RETARD PINK
(12V TO ACTIVATE)
TACH OUTPUT ^GRAY
RED
NOTE: Some 5-pin models may experience
a hesitation or stall on deceleration.
MAP
SENSOR
If this occurs, contact MSD Tech
Line for the required bolt-in diode
to correct the problem. MSD Tech
Line [phone].
HEAVY RED
TO BATTERY
HEAVY BLACK
TO BATTERY
RED - CONNECTS TO 12 VOLTS AND PINK.
WHITE - CONNECTS TO BROWN AND TACH.
RED
WHITE
DISTRIBUTOR CONNECTOR
HALL-EFFECT ^WHITE/BLUE
(NOT USED)
18” BLACK
TO ENGINE
GROUND
Figure 8 Wiring the Programmable 6AL-2 with an HEI 5 or 7-pin module (Amplifier Trigger).
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]