83613 Datasheet, PDF (6/8 Pages) Mallory performance club – MSD Pro-Billet Chevrolet V8 Distributor

6
INSTALLATION INSTRUCTIONS
VACUUM ADVANCE LOCKOUT
If you do not want to use the vacuum advance canister
of the PN 8361/83613, MSD has supplied a lockout
mechanism.
1. Remove the two Allen head screws that hold the
advance canister (Figure 11).
2. Remove the snap ring that holds the magnetic
pickup assembly in place.
3. Gently lift up on the mag pickup plate and slide the
vacuum canister out.
4. Install the Lockout Plate in place of the canister.
Install the two retaining screws.
5. Install the supplied screw and washer through the
Lockout and tighten.
6. It is important to make sure the pickup plate
is parallel with the housing of the distributor
(Figure 12). If it is cocked or slanted, the paddles
of the reluctor may contact the pickup. Check
the clearance by rotating the distributor shaft.
If necessary, use the supplied shims under the
Lockout hold-down to correctly position the pickup
plate.
Note: If no shims were required, use one beneath
the washer of the Lock-Out Hold Down
Screw.
Note: Do not forget to plug the original vacuum
advance hose.
RELUCTOR
PADDLES
MAG PICKUP
PLATE
SNAP
RING
CANISTER
SCREWS
Figure 11 Removing the Vacuum Canister.
Figure 12 Checking Installation of the Lockout Plate.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]