7222 Datasheet, PDF (4/16 Pages) Connor-Winfield Corporation – 2.5V SURFACE MOUNT 5x3.2mm LVCMOS FIXED FREQUENCY OSCILLATOR OSCILLATOR

4
WIRING
INSTALLATION INSTRUCTIONS
GENERAL WIRING INFORMATION
Wire Length: All of the wires of the MSD Ignition may be shortened as long as quality connectors
are used or soldered in place. To lengthen the wires, use one size bigger gauge wire (10 gauge for
the power leads and 16 gauge for the other wires) with the proper connections. All connections must
be soldered and sealed.
Grounds: A poor ground connection can cause many frustrating problems.
When a wire is specified to go to ground, it should be connected to the
battery negative terminal, engine block or chassis. There should always
be a ground strap between the engine and the chassis. Always securely
connect the ground wire to a clean, paint free metal surface.
The 7AL-2 has a ground stud just to the left of the terminal strip. Use this
to ground other MSD accessories (Figure 3).
GROUND
Ballast Resistor: If your vehicle has a ballast resistor in line with the coil
wiring, it is not necessary to bypass it. This is because this wire serves
only as an On/Off switch. The MSD receives its main power directly from
the battery.
Figure 3 Ground Stud.
Terminal
COIL +
COIL -
BAT -
BAT +
TACH
Wire
ORANGE
BLACK
HEAVY
BLACK
HEAVY
RED
Function
Connects to the positive (+) terminal of the coil.This is the only wire that
makes electrical contact with the coil positive terminal.
Connects to the negative (-) terminal of the coil. This is the only wire that
makes electrical contact with the coil negative terminal.
This wire connects to a good ground, either at the battery negative (-) terminal
or to the engine.
This wire connects directly to the battery positive (+) terminal or to a positive
battery junction or the positive side of the starter solenoid. Note: Never
connect to the alternator.
This terminal delivers a 12 volt square wave signal as an output for a
tachometer or devices that require an rpm signal.
2-STEP DARK
BLUE
IGNITION RED
POINTS WHITE
MAG + VIOLET
MAG - GREEN
When this terminal is connected to 12 volts, RPM module 1 is active. When
there is no 12 volts, RPM module 2 is active.
Connects to a switched 12 volt source. Such as the ignition key or switch.
This wire is used to connect to the points, electronic ignition amplifier output
or to the Yellow wire of an MSD Timing Accessory. When this wire is used,
the Magnetic Pickup connector is not used.
These wires are routed together in one harness from the Magnetic Pickup
connector. The connector plugs directly into an MSD Distributor or Crank
Trigger. It will also connect to factory magnetic pickups or other aftermarket
pickups (Figure 4). The Violet wire is pos. (+) and the Green is neg. (-).
When these wires are used, the Points Terminal is not.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]