8963 Datasheet, PDF (3/4 Pages) Mallory performance club – MSD Digital Shift Light

INSTALLATION INSTRUCTIONS
POWERTRAIN CONTROL MODULE
UP DOWN
MODE
GREEN

BLACK GROUND
Note: The shift light must
be programmed
for two (2) cylin-
der operation.
RED
SIGNAL
OUTPUT
GREEN
TRIGGER COIL 2
IGNITION 12 VOLTS
TRIGGER COIL 1
GMR PICKUP
RED
BLACK GROUND
METAL TAB
NOTE: The brass screw must be used for proper operation.
WASHER MUST BE ON TOP OF METAL TAB
SWITCHED
12 VOLT
GGMMRRPPICICKKUUPP
PRIMARY COIL (+) WIRE OR
DIESEL INJECTOR 12 VOLT WIRE
Figure 4 Installing to an Inductive Coil Pack.
BLACK GROUND
UP DOWN
MODE
SHIFT LIGHT
GREEN
GREEN
SWITCHED
12 VOLT
RED
BLACK
GROUND
CHASSIS
GROUND
GMR PICKUP
RED
TM
IGNITION
BLACK
TO GROUND
ON CYLINDER
HEAD
METAL TAB
NOTE: The brass screw must be used for proper operation.
WASHER MUST BE ON TOP OF METAL TAB
GMR PICKUP
PRIMARY COIL (+) WIRE OR
DIESEL INJECTOR 12 VOLT WIRE
Figure 5 Wiring the Pro Mag 44 Electronic Points Box.
NOTE: A momentary push button switch can be connected with tach input green wire to ground to
reset the PN 8963 to the first gear value at any time - normally the RPM must drop to under
1700 rpm for the PN 8963 to reset to the first gear value.
M S D I G N I T I O N • www.msdignition.com • [phone] • FAX [phone]