English
Language : 

646 Datasheet, PDF (3/8 Pages) Littelfuse – MINIATURE FUSEHOLDERS
075
To tachometer
Connect ignition coil and distributor/trigger
wires according to the HYFIREÆ VII instructions
applicable to the distributor/trigger being used
BLACK
FIGURE 3
RPM ACTIVATED SWITCH WITH HYFIRE® VII
DO NOT connect to coil (+) terminal
RED
DO NOT connect to coil (+) terminal.
Connect this wire to a switched 12 volt
source. Switch must be capable of
switching all of the current from the
ignition and device(s).
The ignition may draw up to 1/2 amp.
Minimum of 18GA wire should be used.
P/N 646
MODE
VALUE
L ñ LOW RPM
H ñ HIGH RPM
C ñ CYLINDER SELECT
MODE
WINDOW RPM SWITCH
UP
DOWN
®
BLACK
ORANGE WIRES ñ
Connect to a device to be turned
ON at a selected RPM.
PURPLE WIRES ñ
Connect to a device to be turned OFF at a
selected RPM. NOTE: Relays are required if
device being switched draws more than 5 amps.
To engine block or
chassis ground
FIGURE 4
075
RPM ACTIVATED SWITCH AND
RELAYS WITH HYFIRE® VII
Connect ignition coil and distributor/trigger wires
according to the HYFIREÆ VII instructions applicable to
the distributor/trigger being used
GREEN
To tachometer
These relays are shown as examples
only. Other relays may be used, such
as Blue Streak Part No. RY-48
DO NOT connect to COIL (+) terminal
RED
STANDARD
STANDARD
Connect this wire to a device to be
turned OFF at a selected RPM.
Connect the other wire from the device to
GROUND. NOTE: Relays are required if the
device being switch requires more than 5 amps.
Connect this wire to a device to be
turned ON at a selected RPM.
Connect the other wire from the device to
GROUND. NOTE: Relays are required if the
device being switch requires more than 5 amps.
PURPLE
To engine block or chassis ground
ORANGE
To engine block or chassis ground
DO NOT connect these wires to COIL (+) terminal
Connect these wires to a switched 12 volt source.
Switch must be capable of switching all of the
current from the ignition and devices.
BLACK
To engine block or chassis ground
MALLORY TECHNICAL SUPPORT (775) 882-6600 tech@mrgasket.com
3