81502 Datasheet, PDF (2/4 Pages) Mallory performance club – MSD 20 Amp Pro Mag Generator

2
INSTALLATION INSTRUCTIONS
16 GAUGE
PRO
MAG
ENDURANCE POINTS
& COIL ASSEMBLY
AUTOTRONIC CONTROLS CORPORATION
1490 HENRY BRENNAN DR., EL PASO, TX 79936
SERIAL NO.
PN 8106
PRO MAG 20
Figure 2 Wiring the 20 Amp Pro Mag.
ACCESSORIES
MASTER KILL SWITCH
For applications that require a master
kill switch, MSD offers the PN 8134.
The heavy duty switch can be wired
into the master kill switch to turn the
magneto off (Figure 3).
MAGNETO TACHS
There are two style Magneto Tachs
offered; Voltage triggered and
Inductive triggered. Both can be
used with the MSD Pro Mag but wire
differently.
Voltage Triggered Mag Tachs:
Connect the tach signal wire to the
Orange wire of the Kill Switch. The
tach ground connects to the Black
wire of the Kill Switch (Figure 4).
*NOTE: THE SPACERS MUST BE INSTALLED
BETWEEN THE WIRE TERMINALS
AND RELAY HOUSING.
TO
12 VOLTS
12V SOLENOID
NORMALLY CLOSED
PRO
MAG
ENDURANCE POINTS
& COIL ASSEMBLY
AUTOTRONIC CONTROLS CORPORATION
1490 HENRY BRENNAN DR., EL PASO, TX 79936
SERIAL NO.
PN 8106
BLACK
SPACERS*
TO COIL
ORANGE
LOCK
WASHER
NUT
IGNITION KILL
SWITCH ON DASH
TO COIL
TRACTOR PULL
SLED
APPLICATIONS
BREAK AWAY
SWITCH
GROUND
(CHASSIS)
BOTH SWITCHES HAVE TO BE CLOSED TO START MOTOR.
IF EITHER SWITCH OPENS THE MOTOR WILL STOP.
Figure 3 Wiring the Kill Switch, PN 8134.
16 GAUGE
GROUND
TO HEAD
PRO
MAG
ENDURANCE POINTS
& COIL ASSEMBLY
AUTOTRONIC CONTROLS CORPORATION
1490 HENRY BRENNAN DR., EL PASO, TX 79936
SERIAL NO.
PN 8106
PRO MAG 20
Figure 4 Wiring a Voltage Triggered Tach.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]