6013 Datasheet, PDF (2/8 Pages) Mallory performance club – MSD 6-Hemi® Controller for Carbureted and EFI Hemi® Engines

2
INSTALLATION INSTRUCTIONS
POWER WIRES
Note: For carburetor applications this connector is cut off and the Brown/Yellow is not used. For EFI applications,
this connector connects to the Coil-1 connector (See note on diagram).
RED/GREEN
12-volt input. Connect to switched 12 volts.
BROWN/YELLOW
Use only with EFI. Coil-1 input wire (See note on EFI diagram).
BLACK/GRAY
Ground. Connect eyelet to ground.
LOOSE WIRES
YELLOW
Tach Signal. Provides a 12 volt square wave source.
PINK
Step Retard. When 12 volts are applied, the step retard is activated.
BLUE
2-Step. When 12 volts are applied, the RevLaunch rpm value is active.
BROWN

'06-'07 Harness, PN 88864 only: Waste Spark Control. To disable waste spark, cut
the wire loop.
MAP SENSOR
LIGHT GREEN
Pin-1 Map Signal
BROWN
Pin-2 Ground
ORANGE
Pin-3 5-volt supply
CRANKSHAFT SENSOR
ORANGE
Pin-1 5-volt supply
BROWN
Pin-2 Ground
ORANGE/YELLOW Pin-3 Crank Signal
CAMSHAFT SENSOR
BROWN/WHITE Pin-1 Cam Signal
BROWN
Pin-2 Ground
ORANGE
Pin-3 5-volt supply
COIL CONNECTORS
Note: PN 88864, '06-'07 applications with 3-pin coil connector. Pin 1 is signal and Pin 2 is 12 volt supply.
RED
Pin-1 12-volt supply (for all cylinders)
VIOLET
Pin-2 Coil-1 Trigger
BLACK/GREEN Pin-2 Coil-2 Trigger
LIGHT BLUE
Pin-2 Coil-3 Trigger
BROWN/GREEN Pin-2 Coil-4 Trigger
GREEN
Pin-2 Coil-5 Trigger
WHITE/BLUE
Pin-2 Coil-6 Trigger
PINK
Pin-2 Coil-7 Trigger
VIOLET/BLUE
Pin-2 Coil-8 Trigger
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]