6011 Datasheet, PDF (2/8 Pages) Micronetics, Inc. – SINGLE POLE, SINGLE THROW DROP-IN/CONNECTORIZED SWITCH MODULES

2
INSTALLATION INSTRUCTIONS
POWER WIRES
Note: For carburetor applications this connector is cut off and the Brown/Yellow is not used. For EFI applications,
this connects to the number one coil connector.
RED
12-volt input. Connect to switched 12 volts.
BROWN/YELLOW
Use only with EFI. Coil input wire.
BLACK
Ground. Connect eyelet to ground.
LOOSE WIRES
YELLOW
Tach Signal. Provides a 12 volt square wave source.
PINK
Step Retard. When 12 volts are applied, the step retard is activated.
BLUE
2-Step. When 12 volts are applied, the RevLaunch rpm value is active.
MAP SENSOR
BROWN
Pin-A Ground
GREEN
Pin-B Map Signal
ORANGE
Pin-C 5-volt supply
CRANKSHAFT SENSOR
BLACK
Pin-A Signal Negative (-)
RED
Pin-B Signal Positive (+)
CAMSHAFT SENSOR
BROWN
Pin-A Ground
TAN
Pin-B Signal Wire
COIL CONNECTORS
*Note: The harness is set up for use on a SOHC engine. DOHC engines use coils with reversed polarity. In these
applications, the location of two coil wires needs to be swapped in each connector.
RED
VIOLET
RED/GREEN
LT. BLUE
BROWN/GREEN
GREEN
WHITE/BLUE
PINK
VIOLET/BLUE
Pin-A* 12-volt supply
Pin-B* Coil-1 Trigger
Pin-B* Coil-2 Trigger
Pin-B* Coil-3 Trigger
Pin-B* Coil-4 Trigger
Pin-B* Coil-5 Trigger
Pin-B* Coil-6 Trigger
Pin-B* Coil-7 Trigger
Pin-B* Coil-8 Trigger
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]