5760001 Datasheet, PDF (2/2 Pages) Mallory performance club – TROUBLE SHOOTING GUIDE MAGNETIC TRIGGERED DISTRIBUTORS

5. Keeping your hands away from the coil leads, tap
the blade of your screwdriver to the metal strip of
the magnetic pickup assembly where you mea-
sured the air gap. Each time you tap the blade to
the metal strip, the light on your tester should flick-
er. If the light flickers off or on, your magnetic pick-
up and module are functioning correctly.
6. On distributors with the pickup separate from the
module assembly, you can check the pickup using
your Ohm meter. Connect the leads from your
Ohm meter to the 2 leads of the pickup. If you
show a resistance of 50 to 200 Ohms, the pickup is
functioning correctly. If the Ohm meter shows an
open circuit, the pickup should be replaced. Once
replaced, perform the module and pickup assembly
test procedure again as shown above.
If you need further assistance after following this trouble-shooting procedure, contact Technical Service at
216-688-8300, extension 500 or at www.malloryracing.com for distributor related questions.
MALLORY IS A DIVISION OF THE MR. GASKET PERFORMANCE GROUP
10601 MEMPHIS AVE. #12, CLEVELAND, OH 44144
216.688.8300
FAX [phone]
FORM 1649M
04/05
Made in U.S.A.
Printed in U.S.A.
2
www.malloryracing.com
MALLORY IGNITION