PN6421 Datasheet, PDF (16/28 Pages) Mallory performance club – MSD 6AL-2 Ignition Control

16
INSTALLATION INSTRUCTIONS
  GM IGNITIONS  Wiring an HEI 5 or 7-pin Module (Amplifier Trigger).
NOTE: Some 5-pin models may experience a hesitation or stall on deceleration. If
this occurs, contact MSD Tech Line for the required bolt-in diode to correct
the problem. MSD Tech Line [phone].
2-STEP/LAUNCH ^BLUE
(12V TO ACTIVATE)
HALL-EFFECT ^WHITE/BLUE
(NOT USED)
HEAVY RED
TO BATTERY
HEAVY BLACK
TO BATTERY
RED*
RED _{WJUHMITPEERJUMPER}
WHITE*
DISTRIBUTOR
CONNECTOR
BROWN
MAGNETIC PICKUP
(NOT USED)
GREEN (-)
VIOLET (+)
RED
WHITE
GRAY
TACH OUTPUT
BLACK
TO ENGINE
GROUND
PINK
18" BLACK
CG- ^NDB+
TO GROUND
*ORANGE - CONNECTS TO B+
*BLACK - CONNECTS TO C-
*WHITE - CONNECTS TO BROWN AND TACH
*RED - CONNECTS TO 12 VOLTS AND PINK
BLACK*
ORANGE*
BLACK*
ORANGE*
FACTORY
HARNESS
HEAVY PINK
OR RED FROM
VEHICLE WIRE
HARNESS
TO TACH
  FORD IGNITIONS  Wiring a Ford DuraSpark using White Wire Trigger.
2-STEP/LAUNCH ^BLUE
(12V TO ACTIVATE)
HALL-EFFECT ^WHITE/BLUE
(NOT USED)
MAGNETIC PICKUP
(NOT USED)
GREEN (-)
VIOLET (+)
GREEN TACH
RED
C+
FORD COIL
CONNECTOR
HEAVY RED
TO BATTERY
WHITE
HEAVY BLACK
TO BATTERY
GRAY
TACH OUTPUT
RED
WHITE
+
ORANGE (TO COIL +)
BLACK (TO COIL -)
RED
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]