PN8762 Datasheet, PDF (1/4 Pages) Mallory performance club – MSD Boost Timing Master

MSD Boost Timing Master
PN 8762
ONLINE PRODUCT REGISTRATION: Register your MSD product online. Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.
IMPORTANT: Read the instructions before attempting installation.
Parts Included:
1 – Boost Timing Master, PN 8762
4 – Self Tapping Screws
1 – Control Knob 1 – 2-Pin Connector
1 – Parts Bag
WARNING: During installation disconnect the battery cables. When disconnecting the battery,
always remove negative cable first and install it last.
Note: The PN 8762 must be used with an MSD Ignition Control.
INTRODUCTION
In order to get the most out of your Boost Timing Master, driving tests and fine-tuning are required.
You will want to achieve having the highest advance timing for peak horsepower at low rpm when
boost pressure is low, and retard the timing during boost just enough to prevent knocking or
predetonation.
Note: In setting up the timing curve, a hand held Mighty-Vac or similar tool will allow you to simulate
the boost pressure, while you adjust timing at idle.
PROGRAMMING
Cylinder Select: The Boost Timing Master is programmed
at the factory for 8-cylinder engines. It can easily be
modified for use on 4 and 6-cylinder engines. The
number of cylinders is adjusted by cutting the cylinder
select loops. Figure 1 shows the Cylinder Programming
Loops and how to modify the Unit.
Magnetic Trigger: If you are using a distributor with a
magnetic pickup, such as an MSD, to trigger the ignition
system the White Wire Loop needs to be cut (Figure 1).
If you are using the points or amplifier input of the MSD
Ignition Control, this Loop does not need to be cut.
MOUNTING
Figure 1 Selecting the Cylinders or Trigger Pickup.
The Boost Timing Master can be mounted under the hood, but should be away from direct engine
heat sources. Make sure that the wiring reach their connections. Use the Control as a template to
mark the mounting holes. Remove the unit and drill the holes with an 1/8” drill bit. Use the supplied
screws to mount the unit.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]