PN87286 Datasheet, PDF (1/2 Pages) Mallory performance club – Soft Touch Rev Control for Dirt Motorsports Racing Series

Soft Touch Rev Control
for Dirt Motorsports Racing Series
PN 87286
Note:  This Soft Touch Rev Control, PN 8728, is designed for inductive style ignition systems only.
It cannot be used with an MSD Ignition Control!
Parts Included:
1 - Soft Touch Rev Control
1 - Deutsch Harness
4 - Self Tapping Screws
2 - Terminals
4 - Mounting Pads and Sleeves
WARNING: During installation, disconnect the battery cables. When disconnecting the
battery, always remove the Negative cable first and install it last.
Note: The RPM limit is set with plug-in rpm modules. If an rpm module is not installed, there will
be no rpm limit.
MOUNTING
The Rev Control can be mounted in the engine
compartment but away from direct heat sources. It
is recommended to mount it where the rpm module
is easy to access for rpm adjustments. Make sure
all of the wiring reaches their connections. Once a
suitable mounting location is determined mark the
location of the mounting holes by using the unit as
a template. Remove the unit and use a 1/8” bit to
drill the holes. Install the supplied mounts and use
the four self tapping screws to secure the Control
(Figure 1).
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]