PN8728 Datasheet, PDF (1/8 Pages) Mallory performance club – Soft Touch Rev Control

Soft Touch Rev Control
PN 8728
ONLINE PRODUCT REGISTRATION: Register your MSD product online. Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.
Note:  This Soft Touch Rev Control, PN 8728, is designed for inductive style ignition systems only. It
cannot be used with an MSD Ignition Control!
Parts Included:
1 - Soft Touch Rev Control
4 - Mounting Pads and Sleeves
4 - RPM Modules, 3,000, 6,000, 7,000, 8,000
4 - Wire Splicers
4 - Self Tapping Screws
4 - Wire Insulating Caps
WARNING: During installation, disconnect the battery cables. When disconnecting the battery,
always remove he Negative cable first and install it last.
Note: The RPM limit is set with plug-in rpm modules. If an rpm module is not installed, there will be
no rpm limit.
CYLINDER SELECT
The Soft Touch Rev Control comes from MSD
programmed for 8-cylinder applications. It can
easily be adjusted for operation on other en-
gines by cutting the cylinder select wire loops
(Figure 1). If the loops are cut, use the supplied
insulating caps to seal the wire ends.
MOUNTING
Figure 1 Selecting the Number of Cylinders.
The Rev Control can be mounted in the engine
compartment but away from direct heat sources. It is recom-
mended to mount it where the rpm module is easy to access
for rpm adjustments. Make sure all of the wiring reaches their
connections. Once a suitable mounting location is determined
mark the location of the mounting holes by using the unit as a
template. Remove the unit and use an 1/8” bit to drill the holes.
Install the supplied mounts and use the four self tapping screws
to secure the Control (Figure 2).
Figure 2 Installing the Vibration Mounts.
M S D  • WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]