PN8650 Datasheet, PDF (1/2 Pages) Mallory performance club – Flying Magnet Crank Trigger Kit Pontiac V8 Engines

Flying Magnet Crank Trigger Kit
Pontiac V8 Engines
PN 8650
Important: Read the instructions before attempting the installation.
Parts Included
1 - Trigger Wheel
1 - Pickup Holder Assembly
1 - Trigger Wheel Spacer
1 - Non Magnetic Pickup Assembly
1 - Pickup Base
1-General Wiring Instructions
1-Tech Bulletin #104
2 - Bolts, 5/16" - 24 x 1¼”
4 - Bolts, 5/16"- 18 x 1¼”
4 - 5/16" Washers
4 - Bolts, 3/8"- 16 x 1¼”
2 - Bolts, 3/8" - 16 x 3"
6 - 3/8" Washers
2 - Thin Spacer Washers
Note: On some vehicles the MSD crank Trigger Kit may require slight modifications
to accomodate special engine plates, pulley systems, etc.
INSTALLING THE PICKUP AND BRACKET
1. Install the pickup holder
onto the bracket and snug
the bolts. Only two bolts will
correctly fit the threads of the
pickup base. Do not try to
force the bolts in.
2. Install the pickup bracket
onto the passenger side of
the balancer. Be sure to use
the correct length bolts and
shims in the proper positions.
3. Install the locknut onto the
pickup, then install the
pickup. Do not tighten the
locknut at this time.
Figure 1 Pickup Bracket Assembly.
AUTOTRONIC CONTROLS CORPORATION • 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • [phone] • FAX [phone]