PN8620 Datasheet, PDF (1/2 Pages) Mallory performance club – Flying Magnet Crank Trigger Kit Chevrolet Big Block V8 Engines

Flying Magnet Crank Trigger Kit
Chevrolet Big Block V8 Engines
PN 8620
ONLINE PRODUCT REGISTRATION: Register your MSD product online. Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.
Important: Read the instructions before attempting the installation.
Parts Included:
1 - Trigger Wheel
1 - Pickup Holder Assembly
1 - Non Magnetic Pickup Assembly
1 - Pickup Base
2 - Bolts, 5/16" - 24 x 1¼"
2 - 5/16" Washers
3 - Bolts, 3/8"- 16 x 1¼"
3 - 3/8" Washers
2 - Bolts, 7/16"- 14 x 2" Hex
4 - Spacers
Tech Bulletin #104
Note: On some vehicles the MSD Crank Trigger Kit may require slight modifications to accommodate
special engine plates, pulley systems, etc.
INSTALLING THE PICKUP AND BRACKET
1. Mount the pickup holder onto the bracket
using the two fine thread bolts (Figure 1).
The pickup base will only install one way,
do not try to force the bolts in, and hand
tighten the bolts.
2. Install the bracket onto the engine. The
bracket may be mounted on either side
of the balancer. Be sure to use the correct
length bolts and shims in the proper
location.
3. Install the pickup and locknut into the
holder. Do not tighten the locknut at this
time.
Figure 1 Pickup Bracket Assembly.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]