PN8600 Datasheet, PDF (1/2 Pages) Mallory performance club – Flying Magnet Crank Trigger Kit Chevrolet Small Block Engine with 6¼” Damper

Flying Magnet Crank Trigger Kit
Chevrolet Small Block Engine with 6¼” Damper
PN 8600
ONLINE PRODUCT REGISTRATION: Register your MSD product online and you’ll be entered
in our monthly 8.5mm Super Conductor Spark Plug Wire give-away! Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.
Important:Read the instructions before attempting the installation.
Parts Included:
1 - Bracket
1 - Trigger Wheel
1 - Pickup Mount
1 - Centering Ring
1 - Non Magnetic Pickup Assembly
1 - Locknut
2 - Bolts, 3/8" - 16 x 1.5"
2 - Bolts, 5/16" - 18 x1.25”
3 - Bolts, 3/8" - 24 x 1”
2 - 5/16" Washers

1 - Mount Retainer
Note: On some vehicles the MSD Crank Trigger Kit may require slight modifications to accommodate
special engine plates, pulley systems, etc.
INSTALLING THE PICKUP AND BRACKET
1. Install the pickup mount onto the bracket
using the two 5/16" bolts (Figure 1). The mount
retainer will only install one way, do not try to
force the bolts in. Hand tighten the bolts.
2. Install the bracket onto the engine. The bracket
can only be mounted on the passenger side of
the engine. Be sure to use the correct length
bolts in the proper location.
3. Install the pickup into the holder followed by
the locknut. Do not tighten the locknut at this
time.
BRACKET
3/8" x 1 ½"
NON MAGNETIC
PICKUP
MOUNT
RETAINER
PICKUP
MOUNT
LOCKNUT
5/16" x 1 ¼"
Figure 1 Pickup Bracket Assembly.
INSTALLING THE TRIGGER WHEEL
The trigger wheel is designed so it can be used on engines with a dry sump oiling system as well as stock
dampers. Two centering rings are included; one for use on stock or most aftermarket dampers and one
for use with a dry sump pump drive mandrel (Figure 2).
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]