PN8509 Datasheet, PDF (1/2 Pages) Mallory performance club – Magnetic Signal Stabilizer

Magnetic Signal Stabilizer
PN 8509
Important: Read these instructions completely before attempting any installation.
The Magnetic Signal Stabilizer converts the signal from a magnetic pickup to a square wave trigger
signal for the MSD Ignition Control.
Parts Included:
1-Magnetic Signal Stabilizer, PN 8509
Mount the PN 8509 away from direct engine heat sources. Use a 1/4" sheet metal screw to mount
the unit.
1. Connect the RED wire to a switched 12 volts and the BLACK wire to ground.
2. Connect the YELLOW wire to the WHITE wire of the MSD Ignition Control.
            Figure 1Wiring Diagram for Magnetic Signal Stabilizer.
M S D I G N I T I O N • www.msdignition.com • [phone] • FAX [phone]