PN828783 Datasheet, PDF (1/2 Pages) Mallory performance club – MSD Pro PowerTM LS Coil

MSD Pro Power^TM LS Coil
Red, PN 8287, Single, PN 82878, 8 Pack
Black, PN 82873, Single, PN 828783, 8 Pack
ONLINE PRODUCT REGISTRATION: Register your MSD product online. Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.
IMPORTANT: Read the instructions before attempting the installation.
Parts Included, PN 8287:
1 - Coil
1 - Parts Bag
1 - 2-Pin Connector (installed)
Parts Included, PN 82878:
8 - Coils
1 - Parts Tube, Mounting Hardware
8 - 2-Pin Connectors in second Tube
There are several versions of LS coils used so it is important to verify that the PN 8287 is the correct
coil for your application. This coil was designed for the LS2/3/4/7/9 platform.
MOUNTING
The MSD Coil is designed to be a
direct replacement for most GM
Gen-III, IV and V engines. Due to the
number of applications available, the
mounting or clearance of the coils
may be slightly different. MSD has
supplied different hardware to assist
in mounting the MSD Coil when
the factory hardware will not work.
In some instances, a bracket may
require slight grinding to fit.
1. Remove the coils covers (if
present) from the valve covers.
2. Remove the spark plug wire from
the coil.
3. Disconnect the factory wiring
harness and remove the coil
retaining bolts.
Figure 1 Coil Location and Connector
4. If needed install 2-Pin Connector.
5. Install the MSD Coil in the same position as the factory coil using the factory mounting hardware
or the supplied screws.
6. Connect the factory harness and spark plug wire.
7. Reinstall the coil covers.
IMPORTANT: Notice that the MSD Coil has the connector installed (Figure 1). This 2-pin connector
must be plugged in to the coil. If not, the coil will not operate.
Note: MSD Super Conductor 8.5mm Spark Plug wire sets, PN 32813, PN 32819, PN 32823, PN 32829,
PN 33823 or PN 33829 are recommended.