PN8110 Datasheet, PDF (1/2 Pages) Mallory performance club – Billet Distributor Hold Down Clamp

Billet Distributor Hold Down Clamp
PN 8110
ONLINE PRODUCT REGISTRATION: Register your MSD product online. Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.
Parts Included
1 - Billet Clamp
1 - 3/8" - 16 x 1" set screw
1 - 3/8" - 16 nut
1 - 3/8" Lock Washer
1 - 3/8" Flat Washer
Note: The position of the Billet Hold Down Clamp is imperative to its operation. The end points of
the clamp must seat squarely on the intake manifold as well as the distributor collar.
INSTALLATION
1. Install the set screw into the intake manifold using a 3/16" Allen wrench.
2. Install the Billet Clamp, flat washer, lock washer and the nut on the set screw.
3. Position the clamp on the distributor
collar and tighten the nut. Figure 1
shows the correct installation of the
clamp. If the clamp is excessively
angled and the end points of the clamp
do not properly seat, the clamp will not
tighten properly.
Figure 1 Correct Billet Hold Down Installation.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]