PN7904 Datasheet, PDF (1/2 Pages) Mallory performance club – MSD Pro Mag 12 LT

MSD Pro Mag 12 LT
PN 7904
ONLINE PRODUCT REGISTRATION: Register your MSD product online. Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.
Parts Included:
1 - Pro Mag LT
1 - Band Clamp
1. Locate which cap terminal is going to be the number
one cylinder. Mark on the housing this location then
remove the cap (Figure 1).
2. Loosen the band clamp and position the generator
so the rotor tip is just leading into the number one
cylinder mark indicating the number one cylinder
(Figure 2). This will put the timing approximately 2°-3°
within TDC or where you have the timing set. Note:
Always verify timing with a timing light.
3. Install the cap and spark plug wires.
Cylinder 1
#1 Cylinder
Location
Figure 1 Marking the Number One Location.
Maintenance Parts
Cap/Rotor - PN 7919 Red / PN 79193 Black
Kill Switch - PN 8111
Band Clamp - PN 8148
#1
Cylinder
Location
Figure 2 Positioning the Rotor Tip.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]