PN7763 Datasheet, PDF (1/12 Pages) Mallory performance club – MSD Boost Control Module

MSD Boost Control Module
PN 7763
ONLINE PRODUCT REGISTRATION: Register your MSD product online. Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.
Parts Included:
1 - Controller, PN 7763
2 - 12v Air Solenoids
Parts Bag
FEATURES
Parts Required But Not Supplied:
Power Grid Control PN 7730
4 Port CAN-Bus Hub PN 7740
CO2 Bottle and Pressure Regulator
¼” Camozzi Fittings (Quantity depends on
application)
¼” Air Hose Tubing (Quantity depends on
application)
• Two programmable boost curves for on the fly boost curve changes.
• Two electronically controlled air solenoids for precise wastegate pressure control.
• Direct plug into MSD’s CAN-Bus hub for ease of installation.
• Utilizes the Power Grid data acquisition to help fine tune boost curves.
• Two onboard pressure sensors to measure manifold and wastegate pressure.
• Built-in boost timing retard option.
OVERVIEW
The Boost Control Module allows fine tuning control of the engine’s manifold pressure (boost) in forced
induction engines by managing the pressure on top of the wastegate through a set of electronically
controlled air valve solenoids. The Module integrates with the Power Grid Controller seamlessly
through the 4 port CAN-Bus connector which minimizes wiring.
All Power Grid Modules work through MSD’s CAN-Bus system. The Power Grid Modules are plug
and play installations but may require extension harnesses for remote wiring.
Note: Do NOT cut the wires to the CAN-Bus Harness. In the event an extension harness is needed to
mount the unit in the desired location MSD offers the following extension harnesses-
2’ CAN-Bus extension PN 7782
4’ CAN-Bus extension PN 7784
6’ CAN-Bus extension PN 7786
The module has several programmable features such as Over Boost Shutdown, Spool/Launch RPM
activation once the spool pressure is achieved, Data Acquisition through the Power Grid Control,
and allows for two separate Boost Control Curves for “on the fly” switching. The Module utilizes the
built in data acquisition function of the Power Grid for fine tuning of the Boost Control Curves and the
Boost Retard Curve. The Module is fitted with two 4 bar pressure sensors which eliminate the need
of additional sensors to monitor or data log boost pressure. The Boost Control Module utilizes two
¼” Camozzi (push lock) pneumatic fittings. Attempting to change the fittings may damage the circuit
board and is not recommended by MSD.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]