PN7760 Datasheet, PDF (1/8 Pages) Mallory performance club – MSD Three Stage Delay Timer

MSD Three Stage Delay Timer
PN 7760
ONLINE PRODUCT REGISTRATION: Register your MSD product online. Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.
Parts Included:
1 - Module
1 - Parts Bag
Required Items for Operation:
MSD Power Grid - PN 7730
MSD CAN-Hub - PN 7740
The MSD 3-Stage Delay Timer is an add on module for the Power Grid ignition controller. This module
allows for three additional RPM/Time Switch outputs similar to the RPM/Time switch function built
into the Power Grid (Brown/White wire).
INSTALLATION
The 3-Stage Delay Timer module should be securely mounted near the MSD CAN-Hub. Plug the
3-Stage Delay Timer CAN connector to an available port on the MSD CAN-Bus Hub, PN 7740. Do
NOT cut the CAN-Bus connector wires.
The output wires will switch to ground any time the 3-Stage Delay Timer is programmed to activate
by Time/RPM/ or both settings. The output circuit is a low current circuit designed to be used with a
relay or activation switch. The output wires should not be connected directly to solenoids or lights
(Figure 1).
* EXAMPLE BELOW
SHOULD BE
FOLLOWED FOR
EACH STAGE.
LED
TM
®
PN 7760
3 STAGE
DELAY
TIMER
CONTROL
*
BROWN
SOLENOID
WHITE
ORANGE
MSD
PN 8961
RELAY
86 ^87A 87
85
30
TO
GROUND
MSD CAN
12V
12V
Figure 1
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]