PN75591 Datasheet, PDF (1/8 Pages) Mallory performance club – MSD Programmable Shift Controller

MSD
Programmable Shift Controller
PN 75591
ONLINE PRODUCT REGISTRATION: Register your MSD product online. Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.
WARNING: During installation, disconnect the battery cables. When disconnecting, always
remove the Negative cable first and install it last.
Parts Included:
1 – Shift Controller
1 – Pro-Data+ Software
1 – 9-Pin Harness, 10-Feet
2 – Deutsch Terminated Harnesses
8 – #10 Screws
4 – #10 Nuts
4 – #10 Washers
1 – 1-Pin Harness
10 – Butt Splices
2 – Ring Terminals
Note: Solid core spark plug wires cannot be used with this controller.
The MSD Programmable Shift Controller allows you to
program different rpm points to trigger the shift solenoids.
Any transmission configuration may be used up to a six
speed trans. Programming the rpm and options of the Shift
Controller can be done with MSD’s Hand Held Monitor, PN
7550, or with the MSD Pro-Data+ Software on a Windows
based PC.
The optional Hand Held Programmer/Monitor, PN 7550,
connects through the 9-pin connector on the Control and
features an LCD display that allows you to walk through the
programs as well as monitor the engine’s rpm, the current
gear, alerts and more (Figure 1).
There is also a computer disk supplied with the MSD
ProData+ software. This software is for PCs running windows
95, 98 or NT. All of the adjustable parameters can be reviewed
and set, then uploaded to the Controller. More information
on using this software begins on page 5.
Figure 1 Hand Held Programmer, PN 7550.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]