PN7330 Datasheet, PDF (1/12 Pages) Mallory performance club – MSD 7AL-3, Ignition Control

MSD 7AL-3, Ignition Control
PN 7330
ONLINE PRODUCT REGISTRATION: Register your MSD product online. Registering your
product will help if there is ever a warranty issue with your product and helps the MSD R&D
team create new products that you ask for! Go to www.msdperformance.com/registration.
Important: Read the instructions before attempting the installation.
Parts Included:
1 - 7AL-3, PN 7330
1 - Parts Bag (wires and connectors)
4 - RPM Modules 3000, 7000, 8000, 9000
4 - Retard Modules 2°, 3°, 4°, 5°, 10°, 15° and 20°
4 - Zero Degree Modules
4 - Vibration Mounts
WARNING:  During installation, disconnect the battery cables. When disconnecting the battery,
always remove the Negative cable first and install it last.
Note: The MSD 7AL-3 will retard the ignition timing approximately 4° compared to other MSD Ignitions.
After installation, the timing should always be checked and adjusted at idle and total timing.
COIL RECOMMENDATIONS
The MSD 7AL-3 can be used with a variety of coils, but to receive the best performance, it is
recommended to use an MSD Coil. For drag racing and “short duration” applications, the Pro Power
Coil, PN 8201. For street applications or long duration racing events, the HVC Pro Power Coil, PN
8251 or PN 8261 are recommended. The 7AL-3 may be used with a GM HEI Distributor with an internal
coil, however the Rotor Bushing must be replaced with an MSD Low Resistance Bushing, PN 8412.
MOUNTING
The 7AL-3 can be mounted under the hood, but should be mounted in a position away from direct
engine heat sources. Use the ignition as a template and mark the location of the mounting holes.
Remove the unit and drill the holes using a 1/4" bit. Install the vibration mounts to the 7AL-3 then
mount the ignition using the supplied lock washers
and nuts.
Cylinders Loops to Cut
Remove cap
CYLINDER SELECT
This ignition can be used on 4, 6 (even-fire) or
8-cylinder engines. The ignition is set for 8-cylinder
operation. To program the unit for other engines,
remove the one screw that holds the cover to
reveal two wire loops (Figure 1). Cutting a wire loop
determines the cylinder selection.
8
None
6
One
4
Two
Cut loops
Figure 1 Cylinder Programming.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]