PN4207M Datasheet, PDF (1/4 Pages) Mallory performance club – 2-Port Fuel Pressure Regulators

2-Port Fuel Pressure Regulators
PN 4207, PN 4207M and PN 4210
Note: This product is legal in California only for racing vehicles which may never be operated upon a
highway.
Parts Included in this kit:
1 - 2-Port Fuel Pressure Regulator
1 - Regulator Bracket
1 - Plug, 1/8" NPT
FUEL APPLICATIONS
PN 4207
Gasoline, Automotive/Street and Racing
PN 4207M Gasoline, Marine
PN 4210
Alcohol/Methanol, Automotive/Street and Racing
SPECIFICATIONS:
Inlet and outlet port thread sizes:
Fuel pressure adjustment range:
3/8" NPT Fuel pressure port thread size:
4–12 PSI Maximum inlet pressure:
1/8" NPT
20 PSI
GENERAL INFORMATION
The 2-Port Regulator is designed to regulate fuel pressure between high pressure fuel pumps and
carburetors. The regulator is recommended for Mallory COMP PUMP® 140 Series Electric Fuel
Pump. Also, recommended for Mallory High Performance and Competition Mechanical Fuel Pumps.
MOUNTING PROCEDURE
The regulator may be mounted at any angle.
For maximum efficiency, mount the regulator
as close as possible to the carburetors. DO
NOT mount the regulator on or near exhaust
manifolds.
A bracket is provided for convenient mounting
under an intake bolt. Loosen the four regulator
base and bracket screws. Remove two of
these screws. Position the bracket over the
two screw holes. Install the two screws.
Tighten the four screws between 16 and 19
in./lbs.
FIGURE 1
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]