PN2926 Datasheet, PDF (1/2 Pages) Mallory performance club – High Horsepower Fuel Pump

DANGER
Atomic EFI
PN 2926 - High Horsepower Fuel Pump
WARNING Installation of this product requires detailed knowledge of automotive systems
and repair procedures. Installation of fuel system parts and any fuel tank
modifications must be carried out by a qualified automotive technician. Installation of fuel system
CAUTION ^{parts requires handling of gasoline. Ensure that work is performed in a well ventilated area with an}
approved fire extinguisher nearby. Extinguish all open flames, prohibit smoking and eliminate all
sources of ignition in the area of the vehicle before beginning the installation.
When working with fuel systems, eye goggles and other safety apparel should be worn to protect
NOTICE ^{against debris and sprayed}
there are no fuel leaks.
gasoline.
The
finishe_DAd_NGw_ERork
must
be
thoroughly
checked
to
ensure
WARNING
Parts Included:
CAUTION
1 - Banjo Fitting Kit
1 - 18mm x 8AN Inlet Fitting
NOTICE Fuel pump to
1 - Fuel Pump
fuel tank hardware is not
1 - 6mm x 1 Lock Nut (Pump +)
supplied.
1 - 5mm x .8 Lock Nut (Pump -)
DANGER ^{1 - Copper Washer}
2 - Clamps (Fuel Pump Mount)
The fuel system is under pressure. Do not open the fuel system until the pressure
WARNING has been relieved. Refer to the appropriate vehicle service manual for the
procedure and precautions for relieving the fuel system pressure.
INST_CAL_AL_UIN_TG_IOTH_NE FUEL PUMP
The Atomic High Horsepower Fuel Pump is designed to support engines up to 620hp. The pump
specifications will support the volume and pressure required when being used with a returnless or
return style fuel system.
NOTICE 1. It is recommended to mount the pump close to the gas tank and in a position that is below the lowest
point of the tank.
OUTLET SIDE
-6AN
BANJO FITTING
SUPPLIED
12V
-6AN
CAP
SUPPLIED
ALUMINUM
SHIMS
GROUND
INLET SIDE
DANGER ^{-8AN 1/2" ID FUEL LINE RE-}
QUIRED TO THE TANK
(NOT SUPPLIED)
COPPER
WASHER
WARNING
MAKE SURE
CAUTION ^{COPPER WASHER}
SEATS EVENLY
TO AVOID FUEL
LEAKS
NOTICE
NOTE: IT IS RECOMMENDED TO RUN -8, OR 1/2" LINE FROM THE FUEL TANK TO THE IN-
LET OF THE FUEL PUMP. THIS LINE OR TANK FITTINGS ARE NOT SUPPLIED BY MSD.
Figure 1 High Horsepower Fuel Pump Assembly.
M S D  •  WWW.ATOMICEFI.COM • [phone] • FAX [phone]