PN2357 Datasheet, PDF (1/4 Pages) Mallory performance club – MSD Pro-Billet Cam Sync Distributor

MSD Pro-Billet Cam Sync Distributor
Chevrolet V8, PN 2357
Ford 289/302
Steel Gear, PN 2358; Iron Gear, PN 2359;
Bronze Gear, PN 2360; FE Steel Gear, PN 2363
Parts Included:
1 - Pro-Billet Distributor
1 - Rotor, PN 84211
1 - Distributor Cap, PN 84313
1 - Wire Retainer
2 - 1.5" Self Tapping Screws
1 - Tube of Gear Lubricant
1 - O-Ring (Ford) or Gasket (Chevrolet)
2 - O-Rings (Chevrolet)
WARNING: When installing the MSD, disconnect the battery cables. When disconnecting,
always remove the negative cable first and install it last.
Note: An MSD 6, 7, 8 or 10 Series Ignition is required.
This distributor is equipped with an adjustable Hall-Effect Cam Sync Sensor for fuel injected en-
gines. The Cam Sync can be adjusted to achieve the proper lead time required for the particular
ECU being used.
The distributor also features an adjustable rotor. This allows the rotor phasing to be set properly
and compensate for timing changes.
HALL-EFFECT PICKUP
LED OPERATION
The LED is On whenever the magnet is not in front of the pickup. The LED turns Off when the magnet
passes over the center of the pickup (approximately 40°).
SPECIFICATIONS
Accepts 5 – 18 Volts continuous
Output: Within 1.5 volt on the red wire and .3 volt above ground.
Protected from reverse polarity, short circuit and over voltage.
LED “ON”
PICKUP WIRES
MAGNET ON
SPINNING SHAFT -
LED “ON”
LED “OFF”
PICKUP WIRES
MAGNET ON
SPINNING SHAFT -
LED “OFF”
DISTRIBUTOR HOUSING
DISTRIBUTOR HOUSING
RED: 12-14V
GREEN: SIGNAL
BLACK: GROUND
WIRE FUNCTIONS
LED “ON” (less than .3V)
(1.5V less than RED)
W_LEIR_DE _{“OFF”}
for approx.
40⁰
LED “ON”
FROM
DISTRIBUTOR
Figure 1 Installing the Hall-Effect Pickup.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]