PN2348 Datasheet, PDF (1/2 Pages) Mallory performance club – MSD Hall-Effect Pickup

MSD Hall-Effect Pickup
PN 2348
Parts Included:
1 - Pickup Assembly, 1/2" x 20 x 1.25"
1 - Magnet and Retainer
1 - 3-Pin Weathertight Connector
3 - Weathertight Terminals and Seals
Notes:
• This pickup can be used to replace the non-magnetic pickup used in MSD’s Cam Sync Distributors or
as a cam sync pickup in custom installations.
• Precise machining is required when installing the MSD Hall-Effect Pickup to a cam gear or other engine
component.
• The magnet must be installed with the proper polarity facing the pickup with power supplied, pass the
magnet over the pickup. Polarity is correct when the magnet turns the LED off.
CONNECTOR INSTALLATION
1. Install the Weathertight seals, terminals and connector (Figure 1). It is recommended to use
MSD’s Pro-Crimp Tool, PN 35051, with Weathertight Dies, PN 3509.
2. Strip the sleeve of the wire back then install the seal on the wire.
3. Crimp the exposed wire with the conductor crimp tabs.
4. Once the wire is crimped, crimp the seal tabs over the seal.
5. Position each wire into the connector making sure they are in the correct position for your
application.
MAGNET INSTALLATION
1. The magnet retainer is .383” diameter and requires a mounting hole be drilled.
2. Before installing the magnet, the polarity must be correct. Connect power and ground to the
pickup, the LED will light. Pass the magnet over the pickup. When the LED turns off, the polarity
is correct (Figure 2).
SEAL TABS
CONDUCTOR TABS
CRIMPED
CONDUCTOR TABS
WIRE
SEAL TABS
Figure 1 Installing the Terminals.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]