90SERIES Datasheet, PDF (1/3 Pages) Mallory performance club – POINT TYPE DISTRIBUTOR

FORM 641 (REV. B) 9/99
INSTALLATION INSTRUCTIONS
®
COMP 9000™ 90 SERIES
POINT TYPE DISTRIBUTOR
OLD DISTRIBUTOR REMOVAL
1. Disconnect distributor point wire from negative (–) side of coil.
2. Rotate engine until timing mark on crank balancer lines up with
TDC mark on timing tab.
3. Remove cap from original distributor. Rotor blade should point to
number one spark plug wire terminal of cap. If not, rotate engine
one full turn until timing marks line up again.
4. Note position of rotor blade, remove hold-down clamp at distribu-
tor base and remove distributor from engine.
STARTING THE ENGINE
CAUTION: Before starting the engine, be sure all tools, wires
and miscellaneous objects are clear of moving engine parts.
1. Connect a timing light. Find the area with the best view of the
timing marks.
2. Crank the engine. If it fails to start, rotate the distributor in small
increments left or right until engine starts. Do not exceed more
than ten degrees of rotation either way.
3. Set timing as recommended by the engine manufacturer, then
tighten the distributor hold down clamp. Make sure timing is still
correct. If timing has moved, repeat this procedure.
COMP 9000™ DISTRIBUTOR INSTALLATION
NOTE: The Comp 9000™ adjustment is preset at the factory.
1. Prepare new Comp 9000™ distributor by removing the spark
plug wire retainer and distributor cap.
2. Place the Comp 9000™ distributor into the engine. Do not install
clamp at this time. Raise distributor housing enough to turn rotor,
point rotor blade in direction of original rotor.
3. Seat distributor fully into engine.
NOTE. It may be necessary to turn the oil pump drive with a
long screw driver to fully seat the distributor.
4. Install distributor hold-down clamp. Leave clamp loose enough to
rotate distributor for timing purposes.
5. Install Comp 9000™ distributor cap as follows: move spark plug
wires from old cap to new cap one wire at a time, starting with the
number one cylinder, attach wires to matching terminals on new
cap. Do not attach coil lead at this time.
NOTE: It may be necessary to purchase and install spark plug
wire boots and terminal kit, Mallory part number 669.
6. Install the spark plug wire retainer, then attach coil lead.
7. Attach distributor point harness to negative (–) side of coil.
MALLORY COMP 9000™ SERVICE PARTS
QTY.
DESCRIPTION
PART NO.
1 WIRE RETAINER WITH SCREWS
29744
1 DISTRIBUTOR CAP ASSEMBLY
29745
1 ROTOR ASSEMBLY, RH ROTATION
29772
1 ROTOR ASSEMBLY, LH ROTATION
29773
1 CAP ADAPTER/SHIELD ASSEMBLY W/SCREWS 29748
2 CONTACT POINT SET WITH SCREWS
102 X
1 CONDENSOR WITH BRACKET AND SCREWS
400
1 POINT WIRE HARNESS
29775
1 DISTRIBUTOR CAM GREASE (1/4 OZ TUBE)
26015