84336 Datasheet, PDF (1/2 Pages) Mallory performance club – MSD Distributor Cap

MSD Distributor Cap
PN 8433 and PN 84333
ONLINE PRODUCT REGISTRATION: Register your MSD product online. Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.
Parts Included:
1 - Cap
2 - 10-32 x 1.25” Hex Screws
1 - Wire Retainer
2 - 1.5” Phillips Head Screws
Note: If you need to adapt your spark plug wire boots and terminals to fit the towers of the PN 8433
Cap, MSD offers a kit of nine boots and terminals, PN 8849.
The PN 8433 Cap fits all of the MSD Distributors that use the GM Socket style cap (MSD PN 8437).
It will also fit GM Distributors that use a “window” style cap.
Before installing the new cap, note the location of the spark plug wires. It is a good idea to mark the
location of one wire before removing it while leaving the other wires connected to the old cap. Then,
with the new cap installed, you can install each wire individually avoiding any confusion.
After installing the spark plug wires, position
the retainer over the boots. Align the
mounting bosses and use the supplied 1.5”
self-tapping Phillips head screws to hold
the retainer in place. It may be necessary
to apply a slight amount of lubricant to the
boots to help them seat into the retainer
properly.
PHILLIPS SCREWS
Figure 1 Installing the Wire Retainer.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]